User's Guide
Table Of Contents
- Contents
- 1 Introduction and Getting Started
- 2 Software Configuration
- 3 Advanced Settings
- 4 Product Specifications and Regulatory Information
- Product Specifications
- Regulatory Information
- Federal Communications Commission Notice (FCC – United States)
- Innovation, Science and Economic Development Notice (ISED – Canada)
- ISED Canada ICES-003 Compliance
- FCC and ISED RF Exposure Guidance Statement
- Cellular External Antenna Considerations:
- RF Radiation Exposure Guidance Statement
- Radio Frequency and Transmitted Output Power Information
- Product Certifications and Supplier’s Declarations of Conformity
- Wireless Communications
- Limited Warranty and Liability
- Safety Hazards
- 5 Glossary
5G INDUSTRIAL GATEWAY S2000e USER GUIDE 53
LAN Tab
This page provides settings and information about the S2000e local area network (LAN). The LAN
consists of the device and all connected devices.
IP Passthrough
Turn on IP Passthrough: Check the box to enable IP Passthrough. This will enable the first device
detected on the specified interface to obtain the IP address assigned by the mobile network. NOTE:
When IPPT is turned on, all other devices will lose Internet access.
IPPT Interface: Select an interface from the drop-down. NOTE: When IPPT is enabled on an interface,
all other interfaces will be disabled.
IPv4
IP Address: The IP address for your S2000e, as seen from the local network. Normally, you can use the
default value.
Subnet Mask: The subnet mask network setting for the S2000e. The default value 255.255.255.0 is
standard for small (class "C") networks. If you change the LAN IP Address, make sure to use the correct
Subnet mask for the IP address range of the LAN IP address.