User's Guide
Table Of Contents
- Contents
- 1 Introduction and Getting Started
- 2 Software Configuration
- 3 Advanced Settings
- 4 Product Specifications and Regulatory Information
- Product Specifications
- Regulatory Information
- Federal Communications Commission Notice (FCC – United States)
- Innovation, Science and Economic Development Notice (ISED – Canada)
- ISED Canada ICES-003 Compliance
- FCC and ISED RF Exposure Guidance Statement
- Cellular External Antenna Considerations:
- RF Radiation Exposure Guidance Statement
- Radio Frequency and Transmitted Output Power Information
- Product Certifications and Supplier’s Declarations of Conformity
- Wireless Communications
- Limited Warranty and Liability
- Safety Hazards
- 5 Glossary
5G INDUSTRIAL GATEWAY S2000e USER GUIDE 59
• Start Port: Enter the beginning of the range of port numbers used by outgoing traffic for the
custom application being added.
• End Port: Enter the end of the range of port numbers used by the application.
NOTE: If the application uses a single port instead of a range, type the same value for both the
Start Port and the End Port.
• Protocol: Select the protocol used by the port range from the drop-down list (TCP, UDP, or
both).
• Delete: Check this box to delete a custom application. NOTE: Click on the Port Filtering tab
again to remove deleted custom applications from view on the screen.
Click Save Changes to save any changes made to the custom applications.