User's Guide
Table Of Contents
- Contents
- 1 Introduction and Getting Started
- 2 Software Configuration
- 3 Advanced Settings
- 4 Product Specifications and Regulatory Information
- Product Specifications
- Regulatory Information
- Federal Communications Commission Notice (FCC – United States)
- Innovation, Science and Economic Development Notice (ISED – Canada)
- ISED Canada ICES-003 Compliance
- FCC and ISED RF Exposure Guidance Statement
- Cellular External Antenna Considerations:
- RF Radiation Exposure Guidance Statement
- Radio Frequency and Transmitted Output Power Information
- Product Certifications and Supplier’s Declarations of Conformity
- Wireless Communications
- Limited Warranty and Liability
- Safety Hazards
- 5 Glossary
5G INDUSTRIAL GATEWAY S2000e USER GUIDE 62
Custom Applications
You can add up to ten custom applications. Once defined, these applications can be turned on and off
the same way as pre-defined applications.
• On: Check this box if you want the new application to be able to access the Internet (enabling
port forwarding).
• App Name: Enter a name for the custom application.
• Start Port: Enter the beginning of the range of port numbers to be forwarded.
• End Port: Enter the end of the range of port numbers to be forwarded.
NOTE: If the application uses a single port instead of a range, type the same value for both the
Start Port and the End Port.
• Protocol: Select the protocol used by the port range from the drop-down list (TCP, UDP, or
both).
• Delete: Check this box to delete a custom application. NOTE: Click on the Port Forwarding tab
again to remove deleted custom applications from view on the screen.
Click Save Changes to save any changes made to the custom applications.