User's Guide
Table Of Contents
- Contents
- 1 Introduction and Getting Started
- 2 Software Configuration
- 3 Advanced Settings
- 4 Product Specifications and Regulatory Information
- Product Specifications
- Regulatory Information
- Federal Communications Commission Notice (FCC – United States)
- Innovation, Science and Economic Development Notice (ISED – Canada)
- ISED Canada ICES-003 Compliance
- FCC and ISED RF Exposure Guidance Statement
- Cellular External Antenna Considerations:
- RF Radiation Exposure Guidance Statement
- Radio Frequency and Transmitted Output Power Information
- Product Certifications and Supplier’s Declarations of Conformity
- Wireless Communications
- Limited Warranty and Liability
- Safety Hazards
- 5 Glossary
5G INDUSTRIAL GATEWAY S2000e USER GUIDE 64
HTTPS Tab
Use this tab to configure HTTPS and obtain an SSL certificate for a secure connection.
Enable HTTPS support
Before enabling HTTPS support you must fill out the information below, download a certificate, and
install it on the client device.
To turn on HTTPS support, move the ON/OFF slider to ON. To turn off HTTPS support, move the
ON/OFF slider to OFF.
If the LAN IP is changed, device settings are restored from backup, or device is factory reset, you must
disable HTTPS support, make and save any changes to the certificate fields, and download and install a
new certificate to have a secure connection.
NOTE: Once enabled, if the port is 443 in HTTPS configuration, you can access the Web UI at https://(IP
address or domain name). For other ports, you can access at https://(IP address or domain name):(port
number).
Certificate Settings
Port: Use the default of 443 or enter a port number between 1024 and 65535.
Certificate name: Enter a name for the self-signed SSL certificate. A certificate with this name and a
.crt extension is created. You can install the certificate on the client device to enable secure
connection while accessing the Web UI.