User's Guide
Table Of Contents
- Contents
- 1 Introduction and Getting Started
- 2 Software Configuration
- 3 Advanced Settings
- 4 Product Specifications and Regulatory Information
- Product Specifications
- Regulatory Information
- Federal Communications Commission Notice (FCC – United States)
- Innovation, Science and Economic Development Notice (ISED – Canada)
- ISED Canada ICES-003 Compliance
- FCC and ISED RF Exposure Guidance Statement
- Cellular External Antenna Considerations:
- RF Radiation Exposure Guidance Statement
- Radio Frequency and Transmitted Output Power Information
- Product Certifications and Supplier’s Declarations of Conformity
- Wireless Communications
- Limited Warranty and Liability
- Safety Hazards
- 5 Glossary
5G INDUSTRIAL GATEWAY S2000e USER GUIDE 9
Getting Started
This section provides instructions for getting your S2000e up and running, as well as reset and support
information.
Installing a SIM Card
Your SIM card is a small rectangular plastic card that stores your phone number and important
information about your wireless service. The S2000e supports only Nano SIM cards.
CAUTION! Always use a factory-made SIM card supplied by the service provider. Do not bend or scratch
your SIM card. Avoid exposing your SIM card to static electricity, water, or dirt.
To install a SIM card:
1. Remove the cover from the SIM slots on the back of the device.
2. If necessary, remove the SIM card from the protective sleeve, being careful not to touch the gold
colored contacts.
3. Insert the SIM card into the appropriate slot with the gold-colored contact points facing down.
NOTE: The SIM card will click when properly installed.
4. Replace the cover.
NOTE: Should your SIM card be lost or damaged, contact your network operator.