User's Guide
Table Of Contents
- 1. Product Overview
- 2. UI Reference
- Support
- Admin Password
- Wi-Fi - Settings
- Wi-Fi – Primary Network
- Wi-Fi – Guest Network
- Wi-Fi – Wi-Fi as WAN
- Connected Devices
- Access Control - Devices
- Access Control - Schedules
- Settings - Preferences
- Settings – Software Update
- Settings – Backup and Restore
- Advanced Features – Lan
- Advanced Features – Network
- Advanced Features – Manual DNS
- Advanced Features – Firewall
- Advanced Features – MAC Filter
- Advanced Features – Port Filtering
- Advanced Features – Port Forwarding
- Advanced Features – WAN Configuration
- GPS - Status
- GPS - Local
- GPS - Remote
- GPIO
- VPN
- Remote Management
- About – General Status
- About – Primary WAN
- About - Ethernet WAN
- About – Wi-Fi as WAN
- About – System Status
- 3. Using, Testing, Troubleshooting
- 4. Regulatory Information
User Guide
Skyus 500 (Ninkasi)
Rev 1 Page 39 of 78
inseego.com
VPN
The Skyus 500 allows you to create IPSEC VPNs to establish secure connections to remote
networks over a public network.
VPN Service
This setting enables or disables IPSEC VPN service on your device. When the ON/OFF slider is
ON, VPN is enabled. When OFF, VPN service is not available.
VPN Tunnel Configurations
Once such a tunnel is added, the page would display the list of tunnel configurations.
Administrator can delete, edit, view, change priorities of the tunnel configurations.
Add new VPN Tunnel: Use this button to add a new VPN tunnel. The Add New VPN Tunnel
Dialog appears:
Add New VPN Tunnel: Step 1 out of 5
General Settings
• Start Tunnel — Select whether to start the tunnel automatically upon start up or
manually.
• Enable Tunnel —Check this box to enable the tunnel.
• Tunnel Name — Enter a unique name to identify this VPN.
• Local identity — Enter a unique name to identify the local point of the tunnel.
• Remote identity — Enter a unique name to identify the remote point of the tunnel.
• Local Authentication — Select Pre-shared Key from the drop-down list. This is currently
the only form of authentication available with Skyus 500.
• Pre-shared key — Enter a password used to authenticate to your end of the tunnel
(usually matches the remote password.)
• Remote Authentication — Select Pre-shared Key from the drop-down list. This is
currently the only form of authentication available with Skyus 500.
• Pre-shared key — Enter a password used to authenticate the remote end of the tunnel
(usually matches the local password).
Add New VPN Tunnel: Step 2 out of 5
Local Network