User's Guide
Table Of Contents
- 1. Product Overview
- 2. UI Reference
- Support
- Admin Password
- Wi-Fi - Settings
- Wi-Fi – Primary Network
- Wi-Fi – Guest Network
- Wi-Fi – Wi-Fi as WAN
- Connected Devices
- Access Control - Devices
- Access Control - Schedules
- Settings - Preferences
- Settings – Software Update
- Settings – Backup and Restore
- Advanced Features – Lan
- Advanced Features – Network
- Advanced Features – Manual DNS
- Advanced Features – Firewall
- Advanced Features – MAC Filter
- Advanced Features – Port Filtering
- Advanced Features – Port Forwarding
- Advanced Features – WAN Configuration
- GPS - Status
- GPS - Local
- GPS - Remote
- GPIO
- VPN
- Remote Management
- About – General Status
- About – Primary WAN
- About - Ethernet WAN
- About – Wi-Fi as WAN
- About – System Status
- 3. Using, Testing, Troubleshooting
- 4. Regulatory Information
User Guide
Skyus 500 (Ninkasi)
Rev 1 Page 50 of 78
inseego.com
Enabling SSH
Install debug_mode_enable_sideload_package.secure from WebUI:
http://192.168.1.1/cgi-bin/luci/vzw/sideload
Debug_mode_enable_sideload_package.secure file available here
Root Password
Telnet to 192.168.0.1
Issue Command “fw_printenv” – This should allows the option to change root password
If not, enter passwd and change root password
Once root password is changed, device can be connected over SSH to access Linux File
System
Sideload
Load <FW_filename>.secure from http://192.168.1.1/cgi-bin/luci/vzw/sideload
Specific instructions can be found in WebUI spec