User Manual
Table Of Contents
- Content
- CHAPTER 1 M210-2G description
- Chapter 2 M210-2G connection
- Chapter 3 Command interface reference manual
- Chapter 4 User's Guide
- appendix A How to load a key in A coupler
- appendix B ERROR CODE
M210-2G - DATASHEET - M210-2G
DS - 14
Version 1.1
ISO 7816 T=0 Interface
By connecting TX and RX, a single I/O inspired from ISO 7816 T=0 is obtained.
This interface is fully described in the ISO 7816 standard. It allows the coupler to be driven
directly as in an ISO contact connector or SAM module with the T=0 protocol, thereby
utilising any existing smart card software drivers.
ISO contacts Interface
C1: VCC VDD
C2: RST RST
C3: CLK (internal clock)
C4: - -
C5: GND GND
C6: VPP -
C7: I/O TX – RX connected
C8: -
The CLK signal used in ISO 7816 T=0 is an internal clock (default data rate = 9600 baud).