Data Sheet

Preliminary Data Sheet
April 23, 2020
Page 24/25
Document Ref: isp_ble_DS1907_R4.docx
Insight SiP – Green Side – 400 avenue Roumanille – BP 309 – 06906 Sophia-Antipolis Cedex – France – www.insightsip.com
BLE MODULE
ISP1907
The label of the host device should also include the below IC Statement. When it is not possible, this
information should be included in the User Manual of the host device:
“This device complies with Industry Canada licence-exempt RSS standard(s). Operation is
subject to the following two conditions: (1) this device may not cause interference, and (2) this
device must accept any interference, including interference that may cause undesired
operation of the device.
Le présent appareil est conforme aux CNR d'Industrie Canada applicables aux appareils radio
exempts de licence. L'exploitation est autorisée aux deux conditions suivantes : (1) l'appareil
ne doit pas produire de brouillage, et (2) l'utilisateur de l'appareil doit accepter tout brouillage
radioélectrique subi, même si le brouillage est susceptible d'en compromettre le
fonctionnement.”
8.6. Discontinuity
Normally a product will continue to be manufactured as long as all of the following are true:
- The manufacturing method is still available.
- There are no replacement products.
- There is demand for it in the market.
In case of obsolescence, Insight SiP will follow Jedec Standard JSD-48. A Product Discontinuation Notice
(PDN) will be sent to all distributors and made available on our website. After this, the procedure goes as
follows:
- Last Order Date will be 6 months after the PDN was published.
- Last Shipment Date will be 6 months after Last Order Date, i.e. 12 months after PDN.
8.4 RF Exposure Information
This equipment complies with FCC/IC radiation exposure limits set forth for an uncontrolled environment and meets
the FCC radio frequency (RF)Exposure Guidelines in Supplement C toOET65 and RSS-102
of the IC radio frequency (RF) Exposure rules. At least 20 Cm of separation distance between the transmitting
antenna and the user’s body must be maintained at all times. The host manual shall include the RF exposure
statements. If RF exposure statements and use conditions are not provided,
then the host product manufacturer is required to take responsibility of the module through a change
in FCC ID (new application)
8.5. Informations concernant l'exposition aux fréquences radio (RF)
La puissance de sortie émise par l’appareil de sans-fil est inférieure à la limite d'exposition aux fréquences radio
d’Industry Canada (IC). Une distance d'au moins 20 Cm entre l'antenne émettrice et le corps de l'utilisateur doit être
maintenue en tout temps.
Specification subject to change without notice.