Data Sheet

Preliminary Data Sheet
April 23, 2020
Page 4/25
Document Ref: isp_ble_DS1907_R4.docx
Insight SiP – Green Side – 400 avenue Roumanille – BP 309 – 06906 Sophia-Antipolis Cedex – France – www.insightsip.com
BLE MODULE
ISP1907
1. Block Diagram
This module is based on nRF52 Nordic Semiconductor 2.4GHz wireless System on Chip (SoC) integrating
a 2.4 GHz transceiver, a 32-bit ARM Cortex™-M4 CPU, either 512 kB or 192 kB flash memory, either 128
kB RAM or 24 kB RAM and analog and digital peripherals.
It can support BLE, ANT/ANT+, Thread, Zigbee and a range of proprietary 2.4 GHz protocols, such as
Gazell from Nordic Semiconductor.
Fully qualified BLE stacks for nRF52 are implemented in the S112/S132 SoftDevices which can be freely
downloaded. ISP1907 can then be used in Central, Peripheral or both roles for BLE and for both ends of
other proprietary protocols. nRF52 platform also provides extensive software support for Zigbee and
Thread applications with nRF5 SDK, for ANT applications with S212/S312 SoftDevices.
Ultra-low power consumption and advanced power management enables battery lifetimes up to several
years on a coin cell battery. Despite its very small size 8 x 8 x 1.0 mm, the module integrates decoupling
capacitors, 32 MHz and 32.768 kHz crystals, DC-DC converter including the large inductor,
RF matching circuit and antenna in addition to the wireless SoC.
Only the addition of a suitable DC power source is necessary for low energy connectivity. Sensor
applications require the further addition of appropriate sensors. The antenna was designed to be optimized
with several standard ground plane sizes. When NFC function is available, the NFC tag antenna can be
connected externally.
Specification subject to change without notice.