Quick Start Guide

Left
Right
CHARGING YOUR PROJECTOR
Note: Use only the included AC power adapter.
Plug the AC power adapter into a power outlet, then plug the 9V DC output end
into the projector. The charging indicator lights red while charging, and it turns
green when nished.
To check your battery charge level, refer to the table below:
Notes:
• When the charging indicator ashes green and red, the battery is unable to charge because
it is too hot or too cold. Allow the battery to cool down or warm up to room temperature
and try charging again.
• When the charging indicator ashes red, the projector will turn o soon.
• You can use your projector with the AC power adapter connected for unlimited runtime.
Charging will be slower if the projector is in use.
PACKAGE CONTENTS
• Pico projector
• AC power supply
• Quick Setup Guide
COMPATIBILITY
Works with HDMI-compatible devices (up to 1080p). An HDMI cable is needed (sold
separately).
FEATURES
• 50-lumen output with long-life LEDs
• Projects images up to 80 in. (203.2 cm diagonally) (16:9 aspect ratio)
• Accepts up to 1080p video signals for maximum compatibility
• Internal battery with 100 minutes run time (normal brightness at 50% volume
level—will vary depending on use)
• Oversized speakers and amplier provide upgraded audio
Top
Front
Before using your new product, please read these instructions to prevent any damage.
Flat size (W×H): 14.17 × 9.45 in. (360 × 240 cm)
Final folded size: 4.72 × 4.72 in. (120 × 120 cm)
QUICK SETUP GUIDE
Slim-line
Pico Projector
NS-PR60
CONNECTING YOUR PROJECTOR
Apple® iOS Devices
HDMI
USING YOUR PROJECTOR
Tip: For the best picture, use the projector in a dark room or with a small picture
in a brighter room.
1 Connect your video source device to your projector. See “CONNECTING YOUR
PROJECTOR” above for instructions.
2 Place the projector on a hard, at, and steady surface.
Notes:
• Make sure that the projector has enough ventilation. Do not cover the projector.
• Keep the projector stable. Do not walk around with the projector while in use.
3 Turn on your source device, then slide the OFF/ON switch to ON to turn on the
projector. After turning on your projector, it displays (no signal), then mirrors
your device’s screen.
4 Aim the lens at a screen or blank wall, then turn the FOCUS dial to bring the
picture into focus.
5 Use your video source device to control playback.
6 Press Vol+ or Vol- to adjust the projector’s volume level. Make sure that your
video source device’s volume is set to at least 50%.
Note: You can also play audio through your video source device’s speakers.
7 When you are done using the projector, slide the OFF/ON switch to OFF to
turn o the projector, then turn o your video source device.
Lightning® digital AV adapter
(not included)
HDMI cable
(not included)
OR
30-pin digital AV adapter
(not included)
HDMI cable
(not included)
Mini/Micro HDMI adapter
OPTIONAL
Connect if your device has a
mini or micro HDMI port.
CHARGING INDICATOR
Green
Yellow
Red
BATTERY STATUS
80-100%
31-79%
0-30%
Lens
Charging port
FOCUS dial Headphone
jack
FOCUS
HDMI portOFF/ON switch
Volume -/+ buttons
Charging indicator
NS-PR60_18-0225_QSG_V1_EN.ai 1 5/21/2018 10:47:52 AMNS-PR60_18-0225_QSG_V1_EN.ai 1 5/21/2018 10:47:52 AM
V1
FINAL
FOR PRINT