IN-CS102 OWNER’S MANUAL Mobile Audio System • PLL Synthesizer Stereo Radio • Car CD/MP3/WMA Player • Automatic Memory Storing • Full Detachable Panel • Preset Equalization • Auxiliary Input Function
CONTENTS Previewing all tracks ......................... 11 Repeating the same track ................. 11 Playing all tracks in random .............. 11 Selecting tracks by AS/PS/ D-AUD button ...............................................11 Display information ........................... 12 WMA operation.................................13 Audio DSP (MP3/WMA decoder)......13 Disc notes ...........................................14 Specification..................................... 15 Trouble shooting .....
INSTALLATION Notes: TAKE OUT SCREW BEFORE INSTALLATION • Choose the mounting location where the unit will not interfere with the normal driving function of the driver. Before install the unit, please remove the two screws. Take out screw before installation • Before finally installing the unit, connect the wiring temporarily and make sure it is all connected up properly and the unit and the system work properly. • Use only the parts included with the unit to ensure proper installation.
INSTALLATION grounding of the unit. Note to install the short threading terminal of the mounting bolt to the back of the unit and the other long threading terminal to the dashboard. Sleeve L Key Outer Trim Ring Front Panel Spring Washer Hex Nut Metal Strap R Key Mounting Bolt Plain Washer Tapping Screw 6. Mount the sleeve by inserting the sleeve into the opening of the dashboard and bend open the tabs located around the sleeve with a screwdriver.
INSTALLATION DIN REAR-MOUNT (Method B) If your vehicle is a Nissan, Toyota, follow these mounting instructions. Use the screw holes marked T (Toyota), N (Nissan) located on both sides of the unit to fasten the unit to the factory radio mounting brackets supplied with your vehicle. Side view showing Screw Holes marked T, N Screw Factory Radio Mounting Bracket Hook Screw Hook Dashboard or Console To fasten the unit to the factory radio mounting brackets.
USING THE DETACHABLE FRONT PANEL REMOVING THE FRONT PANEL 1. Press the release button ( ) on the front panel and pull off the front panel. Precautions when handing 1. Do not drop the front panel. 2. Do not put pressure on the display or control buttons when removing or installing the front panel. 3. Do not touch the contacts on the front panel or on the main unit body. It may result in poor electrical contact. 4.
WIRING CONNECTION MAIN UNIT ANTENNA CONNECTOR RED IGNITION SWITCH (ACC+) MEMORY BACK-UP (B+) YELLOW (BLACK) FUSE Rch RED AUX IN CABLE Lch WHITE FUSE FRONT RCA CABLE (BROWN) Rch RED BLACK GROUND (B–) Lch WHITE (GREY) POWER ANTENNA FRONT Lch SPEAKER REAR Lch SPEAKER REAR RCA CABLE BLUE Rch RED Lch WHITE WHITE GREY WHITE/BLACK GREY/BLACK GREEN VIOLET GREEN/BLACK VIIOLET/BLACK 7 FRONT Lch SPEAKER REAR Rch SPEAKER
OPERATION LOCATION OF KEYS 2 15 7 1 3 9 10 11 13 5 19 8 18 20 21 24 12 8 17 4 22 14 23 6 16
OPERATION SWITCHING ON/OFF THE UNIT Switch on the unit by pressing any button (except button (7) and button (4)). When system is on, press PWR button (9) to turn off the unit. SET THE CLOCK Press the DSP button (15), the clock is shown on the LCD display. Then hold down the button until the clock flashes. Then press the MANU/SKIP button (17) to change hours or MANU/SKIP button (16) to change minutes. FACEPLATE RELEASE Press button (7) to detach the removable faceplate.
OPERATION threshold level of stop level, the radio is holding at that preset number for several seconds with release mute, then searches again. RADIO OPERATION • SWITCHING TO RADIO MODE Press MOD button (6) shortly to select radio mode, the radio mode appears in the display together with the memory band and frequency. • STATION STORING Press any one of the preset buttons (14) (1 to 6) to select a station, which had been stored in the memory.
OPERATION CD OPERATION MP3 OPERATION • SWITCHING TO CD MODE If there is no CD inserted in the driver: Gently insert the CD with the printed side uppermost into the CD compartment until you feel some resistance. The CD is drawn into the drive automatically. CD playback begins. If a CD is already inserted in the driver: Keep pressing MOD button (6) shortly until the CD mode display appears.
OPERATION - Repeat the above steps if the newly selected title is again a directory. • Searching From Root Directory Press AS/PS (D-AUD) button for three times. The unit searches file or directory from root by MANU/SKIP UP/DOWN buttons. (D-DIR icon turns on if the name is directory). Display will list all available directories and songs. Select the desired directory/songs by using MANU/SKIP UP/DOWN buttons and BND/LOU (ENTER) button to confirm. If the selected title is a song, it starts to play.
OPERATION WMA OPERATION The unit that can play the WMA disc and the operation is the same with MP3 operation described above.
OPERATION DISC NOTES: A. Notes on discs: 1. Attempting to use nonstandard shape discs (e.g. square, start, heart) may damage the unit. Be sure to use round shape CD discs only for this unit. 2. Do not stick paper or tape etc., onto the label side or the recording side of any discs, as it may cause a malfunction. 3. Dirt, dust, scratches and warping discs will cause misoperation. B. Notes on CD-Rs (recordable CDs)/CD-RWs (rewritable CDs): 1.
SPECIFICATION GENERAL Power Supply Requirements Chassis Dimensions Tone Controls - Bass (at 100 Hz) - Treble (at 10 KHz) Maximum Output Power Current Drain : DC 12 Volts, Negative Ground : 178 (W) x 160 (D) x 50 (H) : : : : ± 10 dB ± 10 dB 4 x 40 Watts 15 Ampere (max.) CD PLAYER Signal to Noise Ratio Channel Separation Frequency Response : More than 55 dB : More than 45 dB : 40 Hz - 18 KHz RADIO FM 87.5 to 107.9 MHz 10.
TROUBLE SHOOTING Before going through the check list, check wiring connection. If any of the problems persist after check list has been made, consult your nearest service dealer. Symptom No power. Disc cannot be loaded or ejected. Cause Solution The car ignition switch is not on. If the power supply is connected to the car accessory circuits, but the engine is not moving, switch the ignition key to “ACC”. The fuse is blown. Replace the fuse. Presence of CD disc inside the player.