Quick Start Manual

ENGLISH 12-0538
Using the iPod/iPhone dock
• When an iPod/iPhone is inserted into the dock, the device goes to
standby mode and then turns o. The boombox charges the
iPod/iPhone when docked.
Note: The volume control on the iPod/iPhone only adjusts the volume of
the headphones connected to it. To adjust the volume when connected
to the boombox, use the volume control on top of the boombox.
To use the iPod/iPhone dock:
1 Insert your iPod or iPhone into the iPod/iPhone dock.
2 Press (power) on the top of your boombox to turn it on.
3 Repeatedly press the SOURCE button until iPod appears on the
display.
If there are any available music tracks on your iPod/iPhone, they will start
playing back from the point playback was last stopped or paused. If there
are no les of the proper format on your iPod/iPhone, iPod blinks on the
display.
4 For more information on controlling iPod playback, see the table on
page one of this Quick Setup Guide or your User Guide.
To receive a phone call on your iPhone:
• If your iPhone has a ring tone, your boombox is muted until the call is
completed, at which time it resumes playing music.
• If your iPhone has a ring tone, your boombox plays the ring tone but
the call is heard through your iPhone. After the call, your boombox
stays in iPod mode and resumes playing music.
Note: The iPhone can remain connected to the dock. It is automatically in
speakerphone mode.
Using the CD player
To use the CD player:
1 Press the SOURCE button repeatedly to select CD mode. NO DISC
appears on the display.
2 Lift the CD door and place a CD on the spindle until it clicks, with the
label side up.
3 Close the CD door and the CD player starts reading the disc, press
button to start playing.
4 For more information on controlling CD playback, see the table on
page one of this Quick Setup Guide or your User Guide.
Playing music from an external sound source
To play music from an external source:
1 Plug an audio cable with a 3.5 mm plug (not included) into the AUX IN
jack on the back of your boombox and into your external sound
source, such as an MP3 player.
2 Turn on your boombox, then press the SOURCE button repeatedly
until AUX appears on the display.
3 Control playback from your external sound source.
Using FM mode
To use FM mode:
1 Turn on your boombox. FM mode is the default mode on your
boombox and is automatically selected.
2 Press the or buttons to tune to the station of your choice.
3 For more information on using FM mode, see the table on page one of
this Quick Setup Guide or your User Guide.
Using headphones
• Use headphones with a 3.5 mm connector in the Headphone jack. Use
corresponding adaptors (available at your local electronics store) if you
have a dierent connector. The speakers are automatically switched o
when the headphones are being used.
Troubleshooting
See your User Guide for details.
Maintaining
See your User Guide for details.
Specications
See your User Guide for details.
Legal notices
FCC Part 15
This device complies with Part 15 of the FCC Rules. Operation of this
product is subject to the following two conditions: (1) this device may not
cause harmful interference, and (2) this device must accept any interfer-
ence received, including interference that may cause undesired operation.
This equipment has been tested and found to comply within the limits for
a class B digital device, pursuant to Part 15 of the FCC Rules. These limits
are designed to provide reasonable protection against harmful interfer-
ence in a residential installation. This equipment generates, uses, and can
radiate radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not
occur in a particular installation. If this equipment does cause harmful
interference to radio or television reception, which can be determined by
turning the equipment o and on, the user is encouraged to try to correct
the interference by one or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit dierent from that to
which the receiver is connected.
• Consult the dealer or an experienced technician for help.
FCC warning
Changes or modications not expressly approved by the party responsible
for compliance with the FCC Rules could void the user’s authority to
operate this equipment.
Canada ICES-003 statement
This Class B digital apparatus complies with Canadian ICES-003.
90-day limited warranty
Visit www.insigniaproducts.com for details.
Contact Insignia:
For customer service, call 1-877-467-4289
www.insigniaproducts.com
© 2012 BBY Solutions, Inc., Inc. All rights reserved. INSIGNIA is a trademark of BBY Solutions, Inc.
Registered in some countries. All other products and brand names are trademarks of their
respective owners.
iPod
iPod