User Manual

www.insigniaproducts.com
14
Understanding Park mode
Park mode can be used when using a car ignition/battery
connection cable (not included). These cables can
usually be purchased and installed at a professional auto
installation shop. After a cable is installed correctly, turn
on Park mode from the Settings menu. When you turn off
your vehicle, your dash cam goes into a low power
(sleep) mode to conserve your vehicle's battery.If you
don't install a car ignition/battery connection cable, you
cannot use Park mode.
In Park mode, your dash cam enters sleep mode, and
only the G-sensor is in standby mode.
If the G-sensor is triggered, your dash cam wakes up and
records one minute of emergency video, then returns to
sleep mode. Within one minute, your dash cam checks
the G-sensor. If the G-sensor is triggered again, your dash
cam starts loop recording for five minutes, then it turns
off and enters park mode again.
Recording an emergency video
An emergency recording starts when the G-Sensor
registers a significant impact (hard braking or a collision)
or you press the Emergency Recording button.
Emergency recordings create protected (locked) files
that are not overwritten by continuous loop recording. In
addition, to make sure that important footage isn’t lost
surrounding an incident, adjacent video clips are locked
if the incident happens within 30 seconds of the
beginning or end of a clip.
To capture an emergency recording, press the left
button once. Your dash cam saves the currently active
recording, then resumes normal recording after the clip
is saved.