Daim Ntawv Qhia Tus Neeg Siv

ManualsBrandsinsignia ManualsWasherINSIGNIA NS-FWM45W3 4.5 Cu. Ft. High Efficiency Front-Load Washer

REMOVING THE SHIPPING HARDWARE

IMPORTANT: Save all bolts and spacers for future use.

1 Place the washer within 4 feet (1.3 meters) of its

nal location, then use an adjustable or 1⁄2” socket

wrench to remove the following from the back of

the washer:

• 4 shipping bolts

• 4 plastic spacers (including rubber grommets)

• 4 power cord retainers

2 Insert the hole caps (attached next to the bolt holes

on the back of the washer) into the bolt holes after

the shipping bolts, spacers, and retainers have been

removed.

CONNECTING THE HOSES TO A

WATER SUPPLY

1 Before connecting the hoses, make sure that there

is a rubber washer in both of the hoses.

2 Install the hose screen washers (included) by

inserting them into the free ends of the inlet hoses

with the protruded side facing the faucet.

3 Connect the water hose (not provided) ends to the

hot and cold water faucets tightly by hand, then

tighten another 2/3 turn with pliers or a wrench.

4 Place the unconnected end of the hoses into a

bucket, then turn on the faucets connected to the

water supply hoses for 10 or 15 seconds to remove

any foreign substances. Turn o the faucets.

PACKAGE CONTENTS

You’ll need

QUICK SETUP GUIDE

4.5 Cu. Ft. High

Eﬃciency

Front-Load Washer

NS-FWM45W3

Hose screen

washers (2)

Drain hose

guide (1)

Nylon tie (1)

User Guide and

Quick Setup Guide

Water hoses (2)

(not included)

Channel-lock pliersLevel

Socket wrench with 1/2 in. (12.7 mm) ratchet

or adjustable wrench

Adjustable wrench

or 9/16 in. (14.3 mm)

open-end wrench

Before using your new product, please read these instructions to prevent any damage.

WARNING

• To reduce the risk of re, electric shock, or injury to persons when using or installing the

washer, read and obey all safety information provided in the User Manual & Installation

Instructions that accompanied the washer.

• Do not install or store this washer in an area where it will be exposed to dripping water or

outside weather conditions. See Choosing a location section in the User Guide.

Note: This washer must be properly grounded and installed as described in these steps and

the User Guide. Electrical service to the washer must conform with local codes and

ordinances and the latest edition of the national Electrical Code, ANSI/NFPA 70.

Cold

Hose screen

washers

Water

hoses

Hot

HOT

Summary of content (2 pages)

PAGE 1
REMOVING THE SHIPPING HARDWARE IMPORTANT: Save all bolts and spacers for future use. QUICK SETUP GUIDE 4.5 Cu. Ft. High Efficiency Front-Load Washer 1 Place the washer within 4 feet (1.
PAGE 2
CONNECTING THE HOSES TO THE WASHER LEVELING YOUR WASHER 1 Connect the water hoses to the water intake connections on the back of your washer. Note: The water supply hose connected to the hot water faucet must be connected to the hot water (H) supply intake, and the supply hose connected to the cold faucet must be connected to the cold (C) water supply intake. 1 Press the four top corners of your washer. If your washer moves when you press a corner, the leg for that corner needs to be adjusted.