User Manual

Tabletop FM/HD Radio Receiver

www.insigniaproducts.com

Setting up your Tabletop FM/HD Radio

Powering your radio

Your Tabletop FM/HD Radio can be powered by either the included AC adapter, or with

four AA sized alkaline batteries (not included). Your tabletop radio only operates on

batteries if the AC adapter is unplugged.

Installing the batteries

1 Open the battery compartment on the back of your radio.

2 Place four AA size batteries (alkaline) in the battery compartment. Make sure to

match the + and - on the battery to the + and - signs in the battery compartment.

3 Close the battery compartment until it clicks into place.

Connecting the AC adapter

1 Plug the small end into the DC IN jack on the back of your radio.

2 Plug the AC adapter into a 120/240V, 50/60Hz power outlet.

CAUTIONS:

• When you replace the batteries, make sure that you use batteries of the same type

and voltage. The batteries are AA size alkaline.

• All batteries should be replaced at the same time.

• Dispose of used batteries by following your local hazardous waste regulations.

• If you don’t plan to use your radio for an extended period of time, remove the

batteries to prevent damage.

Note: The low battery icon flashes when the batteries reach 20% of capacity.