User Manual
Table Of Contents
- Contents
- Introduction
- IMPORTANT SAFETY INSTRUCTIONS
- SAVE THESE INSTRUCTIONS
- Features
- Unpacking your washer
- Choosing a location
- Installing your washer
- Using your washer
- Maintaining your washer
- Troubleshooting
- Specifications
- ONE-YEAR LIMITED WARRANTY
21
1.6 Cu. Ft. Portable Top-Load Washer
www.insigniaproducts.com
Step 4b: Connect to water with separate faucets
1 Make sure that there are rubber washers inside the fittings at both ends of
each water hose. Installing the water supply hoses without rubber washers
can cause water leakage.
2 Tighten the hose and faucet fittings by hand until they are snug, then tighten
them an additional two-thirds of a turn with pliers or a wrench. Pull the water
supply hoses downwards to make sure that they are connected securely.
Caution: Do not connect multiple water supply hoses together to increase the
length of the hose. Hoses connected this way can leak and cause electrical shock. If a
hose is too short, replace the hose with a longer, high-pressure hose.
Caution: Do not overtighten the fittings or apply tape or sealant to the faucets or
water supply intakes. This can damage the fittings.
Fitting
Rubber washer
HotCold