User Manual

USER MAINTENANCE INSTRUCTIONS
37
www.insigniaproducts.com
The water
temperature isn’t
correct
• Make sure that you’ve selected the correct temperature.
• Make sure that the water source faucets are fully opened.
• Make sure that the hoses are connected to the correct faucet
and water intake connections on your washer, then flush the
lines. See Step 2: Connect the water hoses on page 20.
• Disconnect the hoses and clean the hose filter screens. The
hose may be clogged.
Load is too wet at
the end of the
cycle
• Use a high-efficiency detergent to reduce over-sudsing. See
Step 1: Select a detergent
on page 30.
• The load may be too small. Very small loads (one or two items)
may become unbalanced and not spin out completely.
Water leaks • Make sure that all hose connections are tight. See Step 2:
Connect the water hoses on page 20
and Step 3: Connect the drain hose on page 22.
• Make sure that the end of the drain hose is correctly inserted
and secured to the drainage system. See Step 3: Connect the
drain hose on page 22.
• Avoid overloading.
• Use a high-efficiency detergent to reduce over-sudsing. See
Step 1: Select a detergent
on page 30.
• Shut off the faucets and remove the hose connections. Make
sure that rubber filters and seals are in correct place and not
cut.
Load has too
many suds
• Use a high-efficiency detergent to reduce over-sudsing. See
Step 1: Select a detergent
on page 30.
• If you have “soft” water, reduce the amount of detergent.
• For small or lightly soiled loads, reduce the amount of
detergent.
Washer has an
odor
• Periodically run a Tub Clean cycle to clean the tub. See
Cleaning the tub
on page 34.
• Use a high-efficiency detergent to reduce over-sudsing.
Excessive suds collect in nooks and crannies and cause odor.
See Step 1: Select a detergent on page 30.
• Dry the interior of your washer after the total cycle has
finished.
PROBLEM SOLUTION