User Manual

15
Top-Load Washer
www.insigniaproducts.com
INSTALLATION INSTRUCTIONS
Installing your washer
Tools you will need
Step-by-Step instructions
Step 1: Select a location
Before you install your washer, make sure that the location:
• Is a hard, level surface without carpeting or soft flooring that can obstruct ventilation.
• Is away from direct sunlight.
• Has adequate ventilation.
• Is not exposed to freezing temperatures (32° F or 0° C).
• Is away from heat sources such as oil or gas.
• Has enough space so that the washer does not rest on its power cord.
Step 2: Connect the water hoses
1 Make sure that there are rubber washers inside the fittings on one end of each new water hose. A filter with an
integrated washer will be installed on the other end of each hose. Installing the water supply hoses without
rubber washers can cause water leakage.
Note
: The water supply hoses are not supplied with your washer and must be purchased separately.
CAUTION
:
• Use new water supply hoses. Using old hoses can result in leakage or overflow that can damage your property.
• Do not connect multiple water supply hoses together to increase the length of the hose. Hoses connected this way
can leak and cause electrical shock. If a hose is too short, replace the hose with a longer, high-pressure hose.
Pliers
Phillips
screwdriver
Level
Washer inlet
hoses
Flat-head
screwdriver
Wrench
Fitting
Rubber washer