User Manual
Table Of Contents
- Contents
- Introduction
- Important Safety Instructions
- SAVE THESE INSTRUCTIONS
- Features
- Unpacking your washer
- Choosing a location
- Installing your washer
- Using your washer
- Washing a load of laundry
- Setting the child lock
- Washer options and settings
- Maintaining your washer
- Troubleshooting
- Specifications
- ONE-YEAR LIMITED WARRANTY
17
Top-Load Washer
www.insigniaproducts.com
INSTALLATION INSTRUCTIONS
4 Connect the ends of the water supply hoses to the water supply intake connections at the top of the washer.
Make sure that the rubber washers are in place. The water supply hose connected to the hot faucet must be
connected to the hot water supply intake and the water hose connected to the cold faucet must be connected
to the cold water supply intake.
5 Tighten the fittings by hand until they are snug, then tighten them an additional two-thirds of a turn with a
wrench.
6 Turn on the hot and cold water supplies and check all the water supply intake connections and the faucets for
water leaks.
Notes
:
• If you do not want to use the hot water supply hose, insert a water intake cap into the hot water supply intake hole.
In this case, you must select the Tap Cold option for the water temperature.
• No intake cap is provided with your washer. It must be purchased separately.
CAUTION
:
• Do not overtighten the fittings or apply tape or sealant to the faucets or water supply intakes. This can damage the
fittings.
• Make sure that the water supply hoses are not twisted or bent. A bent or twisted hose can leak and cause an electric
shock due to the water leakage. To ensure the correct water usage, connect both hot and cold water faucets. If either
or both are not connected, an error code could occur.