User Manual

27
Top-Load Washer
www.insigniaproducts.com
USER MAINTENANCE INSTRUCTIONS
3 Unplug your washer from the electrical outlet
and leave your washer lid open to let air
circulate inside the tub.
Troubleshooting
CAUTION: If your washer has been stored in below-freezing
temperatures, allow time for any leftover water in your washer
to thaw out before use.
CAUTION: Do not try to repair your washer yourself. Doing so invalidates the warranty.
PROBLEM SOLUTION
Washer does not start
• Make sure that your washer is plugged in.
• Make sure that the lid is closed.
• Make sure that the water source faucets are open.
• Make sure that you press the /Start Pause button to start your washer.
• Before your washer starts to fill, it makes a series of clicking noises to make sure that the lid is
locked and to do a quick drain.
• Make sure that the Child Lock is not activated. See Setting the child lock
on page 25.
• Make sure that the Delay option is not turned on. See Step 5: (Optional) Set a delayed start time
on page 23
.
• Check the fuse or reset the circuit breaker.
No water or not
enough water
Detergent or softener
is still in its
compartment after the
wash cycle is
completed
• Make sure that both faucets are fully turned on.
• Make sure that the water pressure is in the range listed in Water requirements
on page 14.
• Make sure that the water inlet hoses are not kinked. Straighten if necessary.
• Disconnect the hoses and clean the screens. The hose filter screens may be clogged.
Washer vibrates or is
too noisy
• Make sure that your washer is set on a level surface. If the surface is not level, adjust your
washer’s feet to level your washer.
• Make sure that your washer is not touching any other object.
• Make sure that the laundry load is balanced.
• During the spin process, if clothes are piled to one side of the tub, your washer may stop because
of the imbalance. Your washer tries up to three times to solve the problem automatically. If the
washer cannot solve the problem, try to manually redistribute clothes inside the tub.
Washer stops
• Make sure that the power outlet is a working outlet.
• Check the fuse or reset the circuit breaker.
• Close the lid, then press the /Start Pause button to start your washer. For your safety, your
washer does not spin unless the lid is closed.
• Before your washer starts to fill, it makes a series of clicking noises to make sure that the lid is
locked and to do a quick drain.
• Sometimes your washer may pause between stages in the cycle. Wait to see if your washer starts
again.
• Disconnect the inlet hoses and clean the screens periodically. The hose filter screens may be
clogged.
Lid is locked or will not
open
• Press the /Start Pause button to pause the washer. You cannot open the lid if the washer is
running.
• After you pause the washer, it may take a few seconds for the lid lock to release.
• If the lid is locked when your washer is not running, press the /Power button to turn on your
washer.
• If power fails while your washer is running, when power is restored, the lid unlocks. Your washer
waits three minutes, then runs the rest of the cycle.