Instructions / Assembly

Installation Instructions
1. Insert six screws (1) through the sink
bowl connection lip (or loose ring), flat
gasket (2) and mounting flange (3). With
screws protruding through the mounting
flange (3) attach six washers (4) and six
nuts (5). Tighten all screws evenly.
2. Position the disposer for plumbing
hookup and check the location of the
keyhole slots in the disposer body flange.
3. Attach two screws (7) through opposite
holes in the mounting gasket (6) and
into the threaded fasteners in the
mounting flange (3). The screws (7)
should be protruding approximately
1/4 inch below the mounting gasket (6).
4. Position the disposer beneath the
mounting gasket (6) and engage the two
protruding screws in the keyhole slots
in the disposer body flange. Assemble
the remaining four screws (7). Tighten
all screws evenly to secure the unit.
Mounting Adaptor (#11327-H)
Part No. 13966-H October 2007
This adaptor will fit a sink opening of:
4-1/2" I.D. and 6-7/8" O.D.
5-7/8" I.D. and 6-1/2" O.D.
5-7/8" I.D. and 6-7/8" O.D.
with 5-1/2" bolt hole circle
Sink Bowl
Connection Lip
Threaded Fasteners
(3) Mounting Flange
(#11189-A)
(4) Washer
(#11180)
(5) Nut
(#11179)
(2) Flat Gasket
(#11292-C)
(1) Screw
(#11294)
(7) Screw
(#1491)
(6) Mounting Gasket
(#11016)
Disposer
Body Flange
Keyholes
Sink