Installation Guide

Le logo Emerson est une marque de commerce et une marque de service de Emerson Electric Co.
Imprimé aux É.-U. © 2015 InSinkErator, une unité commerciale d'Emerson Electric Co. Tous droits réservés.
Le logo Emerson est une marque de commerce et une marque de service de Emerson Electric Co.
Imprimé aux É.-U. © 2015 InSinkErator, une unité commerciale d'Emerson Electric Co. Tous droits réservés.
1
ENGLISH
Installing Bio-Charge
®
Bottle
Use only InSinkErator
®
Bio-Charge
®
septic assist bottles. Do not squeeze the Bio-Charge
®
Bottle; squeezing the bottle may cause Bio-Charge
®
to
discharge and spill.
• Unscrew Bio-Charge
®
dispenser cap nozzle counterclockwise until nozzle pops upward to dispensing position. Do not remove dispenser cap
nozzle.
• Align bottle with concave side toward disposer. IMPORTANT: Press septic assist bottle firmly into place. The bottle MUST be seated into the
dispose housing for proper operation; there SHOULD NOT be a gap. (When installed correctly, the button on the disposer housing will be
fully ejected.
• Release button. Pull bottle down slightly to ensure it is engaged.
Replacing Bio-Charge
®
Bottle
To keep your septic system operating at peak efficiency, replace the Bio-Charge
®
bottle when it is empty.
• Make sure disposer is off.
• Press button on disposer just above bottle and pull bottle down to remove it. (Do not refill or reuse empty bottle.)
INSTALLING AND REPLACING THE BIO-CHARGE
®
BOTTLE