Installation Guide

1
2
3
Brass Nut
Ferrule
Brass Insert
Wing Nut
Plug
Fiber
Washer
Brass Nut
Ferrule
Wing Nut
Fiber
Washer
Property Damage: Do not pinch or break copper
tubing. Do not distort the last 1 inch of tubing.
HC1100 / GN1100
HC1100 / GN1100
HC1100 / GN1100
7
HC1100 / GN1100
nn
From under the sink, place the
semi-circular mounting plate onto
the threaded stud.
nn
Place hex nut onto the threaded stud.
Ensure faucet head is at desired angle.
nn
Insert screwdriver into hole on side of
hex tool (creating a “T”), and use tool
to tighten nut and secure faucet.
2
Semi-circular mounting plate should
encircle all descending tubes and
extend beyond sink hole when tight.
nn
Ensure that the black O-ring is
properly seated in the base of the
dispenser head (the groove on the
underside of the dispenser).
1
2
3
Brass Nut
Ferrule
Brass Insert
Wing Nut
Plug
Fiber
Washer
Brass N
ut
Fer
rule
Wing Nut
Fiber
Washer
1
2
3
Brass Nut
Ferrule
Brass Insert
Wing Nut
Plug
Fiber
Washer
Brass Nut
Ferrule
Wing Nut
Fiber
Washer
1
2
3
Brass Nut
Ferrule
Brass Insert
Wing Nut
Plug
Fiber
Washer
Brass Nut
Ferrule
Wing Nut
Fiber
Washer
nn
Feed tubes down through the hole
in the sink or countertop until the
base is at rest on the sink or
countertop surface.
1
2
3
Brass Nut
Ferrule
Brass Insert
Wing Nut
Plug
Fiber
Washer
Brass Nut
Ferrule
Wing Nut
Fiber
Washer
nn
Unpack dispenser components.
nn
On a firm, flat surface, carefully
straighten the copper tubing.
An assistant may be needed to hold
the dispenser head in place
while securing the dispenser.
B
A
C
D
Make sure to use rubber O-ring
to ensure proper seal.
INSTALLING THE FAUCET - SERIES 1100