Installation Sheet

FILTRATION INFORMATION
Do not use with water that is microbiologically unsafe or of unknown quality without adequate
disinfection before or after the system.
To reduce the risk associated with property damage due to water leakage or flooding:
•ReadandfollowUseInstructionsprovidedwiththeoriginalsystembeforeinstallation
and use of this product.
To reduce the risk of water leakage or flooding, and to ensure optimal filter performance:
•Changethedisposablefiltercartridgeeverysixmonthsorsoonerifyou
observe a noticeable reduction in water flow rate.
• Failure to replace the disposable filter cartridge at recommended intervals may
lead to reduced filter performance and cracks in the filter housing, causing
water leakage or flooding.
•ForsystemsusingtwohandleHCmodelfaucets,operateonlyonehandle
at a time.
•Forquestionsorconcerns,pleasecontactCustomerServiceat
1-800-558-5700.
The InSinkErator Instant Hot Water Dispenser Filtration System offers two levels
of filtration, depending on the filter used: F-1000S is intended for use in filtering
particulates, chlorine taste and odor from drinking water, and has not been evaluated
for other uses; F-2000S reduces particulates, chlorine taste and odor, plus cysts,
lead, mercury, asbestos, benzene, atrazine, 2,4-D, Lindane, Carbofuran and
p-Dichlorobenzene. The system is typically installed (near or beneath a sink) where
filtered drinking water is desired, and must be installed, operated and maintained as
specified in the installation and use instructions.
16
NOTICE
F-1000 Cartridge (included with this system) Chemical & Mechanical Reduction Filter Specifications:
This cartridge provides mechanical and chemical reduction of chlorine taste & odor and particulate class III.
Filter Capacity:
500 gallons, depending on local water conditions. Note that while the testing was performed under
standa
rd laboratory conditions, actual performance may vary. Do not use with water that is microbiologically unsafe or
of unknown quality without adequate disinfection befo
re or after the system. For cold water use only.
Systems must be
installed and operated in accor
dance with the Manufacturer’s recommended procedures and guidelines. See warranty
ca
rd for warranty. For service and parts, contact your local dealer or InSinkErator
®
directly at 1-800-558-5700.
A
pplication guidelines/Water Supply Parameters for NSF Testing: Service flow of 0.75 gpm, community or
private well water suppl
y, water pressure of 20-120 psi (138-827 kPa), water temperature of 33˚F–100˚
Nominal
Particulate Class III,
≥5 µm to <15 µm
270,000 pts/mL
2.1 mg/L 2.0 mg/L ± 10%
At least 10,000
particles/mL
82 pts/mL 99.9%
≥85%
0.06 mg/L 97.0% ≥ 50% J-00082587
J-00119308
F Except as
noted, all testing performed at pH = 7.5
± 0.5, Flow: 0.75 gpm, Pressure: 60 psi, Temp: 20˚± 3˚C.
Contact an authorized InSinkErator service agent for repairs or replacement components. Replacement filters
F-1000 and F-2000 can be ordered by calling 800-558-5700, visiting shop.insinkerator.com, or by contacting
an authorized InSinkErator reseller.
Refer to the Performance Data Sheet for InSinkErator Filter System Model F-2000S
Replacement Cartridge: F-2000
Pressure: 30-120 (207-827 kPa) psi
Temperature: 33
º
F - 100
º
F
Flow Rate: 0.75 gpm
Capacity: 500 gallons
Tested & Certified by NSF International against NSF/ANSI Standard 42 in the following
InSinkErator Systems Only: GN1100, HC1100, GN2200, HC2200, GN2215, HC2215,
H3300 or HC3300 for the reduction of claims specified on the Performance Data Sheet.
For systems using two handle HC model faucets, operate only one handle at a time.