F-HC3300C F-HC3300BR F-H3300C F-H3300BR F-HC1100C F-HC1100BR F-GN1100C F-GN1100BR SWT-FLTR-1, -2, -3, -4 SWT-3, -7 Installation Manual English Manual de instalación Español Manuel d’installation Français Installationshandbuch Deutsch Installatiehandleiding Nederlands Manual de Instalação Português Руководство по установке Русский steaming hot water tap filtered 98°C water on tap Installationsvejledning Dansk Manuale di installazione Italiano Instrukcja instalacji Polski 설치 매뉴얼 한국 安装手册 中文 2
WHAT YOU SHOULD KNOW BEFORE YOU BEGIN ■ For your satisfaction and safety, read all instructions, cautions and warnings before installing or using this Equipment Required: ■ ■ ■ ■ ■ Drill ■ Compression fitting, T-fitting ■ ■ ■ ■ ■ steaming hot water tap. Make sure that all electrical wiring and connections conform to local codes. A standard, earth (grounded) electrical outlet is required under the sink for the tap’s electrical power.
START HERE PROPER INSTALLATION SHOULD TAKE ABOUT 2-4 HOURS PREPARATION HOW TO USE THIS INSTRUCTION MANUAL These instructions are separated into main sections, indicated by numbers, and subsections, indicated by capital letters. The manual is set-up this way to allow you to take a break at any point after completing a section or subsection without affecting the installation process. A HC1100/GN1100 ■ Unpack hot water tap components. ■ On a firm, flat surface, carefully straighten the copper tubing.
2A INSTALLING THE TAP - HC3300/H3300 HC3300/H3300 ■ Unpack hot water tap components. ■ The recommended installation for this 3A MOUNTING THE TANK tap is the tap handle on the right. The unique design allows the handle to be fully functional when placed to the right or left of the hot water tap. Determine preferred handle placement before installing. Property Damage: Do not pinch or break copper tubing. Do not distort the last 25mm of tubing.
A INSTALLING FILTRATION ■ Mark hole locations for filter head and bracket in a spot that allows for filter replacement. 6A FINAL WATER CONNECTION UK/IRL AUS/NZ Wall mount clip ■ Drill 3mm starter holes and attach Back flow protection valve bracket to wall with wood screws, turning until snug. ■ Remove red filter cap, insert filter cartridge into filter head and twist clockwise until “LOCK” arrow on the filter aligns with arrow on bracket.
CARE AND USE Electric Shock Hazard: To prevent electrical shock, disconnect power before servicing unit. Use only a properly earthed (grounded) and polarized electric outlet. ADJUSTING THE THERMOSTAT approx. 96°C Factory temperature pre-set is 96˚C. To reset the thermostat to 96°C, turn the indicator one notch to the right of vertical. After adjusting, depress the tap handle for 20 seconds for water to re-heat to the new setting.
WARRANTY INFORMATION Tap: 2-year warranty SWT-FLTR (tank used with filter): 2-year warranty SWT (tank used without filter): 1-year warranty This warranty is provided by InSinkErator, a division of Emerson Electric Co.
