Programmer's Manual
Table Of Contents
- Explanation of Symbols
- How to Use this Guide
- Chapter 1: Therapy Overview
- Chapter 2: Programmer Components
- Chapter 3: Getting Started
- Chapter 4: Screen Descriptions
- Chapter 5: Clinical Programming Sessions
- Chapter 6: Troubleshooting
- Chapter 7: Warnings and Precautions
- Chapter 8: Supplemental Information
- Chapter 9: Inspire Medical Systems, Inc. Limited Warranty
52 English Programmer Model 2740
Select a Preset
Use the Select a Preset button to change sensing settings to one of the following:
• Initial Session Settings — Selects the generator sensing settings from the start of the current
programming session.
• Current Generator Settings — Selects the sensing settings currently in use by the generator.
Note: Selecting the Current Generator Settings preset clears all highlighting.
• Default Settings — Selects the default sensing settings (see “Default Settings” on page 96 for more
information).
Sense History
Select the Sense History button to access sensing settings stored in the programmer from earlier in the
session or from previous sessions.
Advanced Screen View
Figure 4-18. Adjust Sensing Screen, Advanced View
To modify advanced sensing settings, select the Advanced tab at the bottom of the screen (Figure 4-18).
• Use the arrow buttons to increase or decrease the following settings.
– Exhalation Threshold
– Soft Off Period
– Inhalation Sensitivity
– Inhalation Threshold
– Amplitude
– Max Stim Time
• Select Check Pressure button to measure the current peak-to-peak sensor pressure. Measurement
results are most accurate when the sensing has been allowed to synchronize with
the patient’s respiration for several minutes.
Note: This button is enabled only when therapy is on.