User's Manual
2
D. Battery
The Fall Sensor uses one 3V lithium battery as its power source.
If the battery voltage is low, a Low Battery signal will be sent to the Control Panel to notify the user.
Moreover, when it s operated in low battery status, the Red LED will Flash to remind the user to replace
the battery.
<
<
N
N
O
O
T
T
E
E
>
>
) It is prohibited to learn-in Fall Sensor to the Control Panel when Fall Sensor is in low battery
status.
E. Inactivity Detection
If a fall is detected, the sensor will transmit an alarm signal to Control Panel. If no sudden movement was
detected within 10 seconds after fall detection, an inactivity code will be sent to Central Monitoring Station
to notify CMS of user’s inactivity condition.
F. Usage Recommendation
1. If a fall sensor is placed steadily in one position for more than 3 hours, a sleep timer-1 minute will be
activated. During one-minute sleep time, the fall sensor will not be triggered due to put-on movement.
After 1 minute, the fall sensor will be back to normal function.
2. Please place a fall sensor outside of a coat. Do not cover it with any clothes.
3. Carefully place the fall sensor on a desk when you are not using it in order to avoid triggering an alarm.
4. Due to the nature of fall detection mechanism, fall detection cannot be 100% accurate. False alarm or
detection failure during daily use could not be avoided completely, please utilize the Active Button to
activate alarm manually when needed to ensure safety.
G. Testing
During testing, do not trigger the fall sensor twice within a 10-second interval.
F
F
C
C
C
C
S
S
t
t
a
a
t
t
e
e
m
m
e
e
n
n
t
t
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:
(1) This device may not cause harmful interference, and
(2) This device must accept any interference received, including interference that may cause undesired
operation.
F
F
C
C
C
C
C
C
a
a
u
u
t
t
i
i
o
o
n
n
:
:
To assure continued compliance, any changes or modifications not expressly approved by the party
responsible for compliance may void the user's authority to operate this equipment. (Example - use only
shielded interface cables when connecting to computer or peripheral devices).