User's Manual

2
E. Fall Detection and Sleep Mode
 If a fall is detected, the sensor will activate the Main Unit (transmitting the same code as pressing
the Active Button).
 If the fall sensor remains stationary for more than 3 hours, it will enter Sleep Mode. During Sleep
Mode, If movement is detected during sleep mode, the fall sensor will start a 1-minute countdown
to return to normal operation mode (you can return to normal operation instantly by pressing on
the Active Button once). Fall detection function is disabled during the 1-minute timer. After the
1-minute timer expires, The Fall Sensor will return to normal operation. This function is designed to
allow user to don the Fall Sensor after removing it for extended period without activating false
alarm.
F. Usage Recommendation
 Please do not cover the fall sensor with clothes (wear it so it is visible to the eye)
 Carefully place the fall sensor on a desk while not in use to avoid accidental alarm trigger.
G. Changing the Battery
 Remove the battery compartment cover by unscrewing the screw using a Philips screwdriver.
 Carefully remove the coin battery using a Philips screwdriver.
 Press the Active Button twice to fully discharge.
 Insert the coin battery taking care of polarity.
 Replace the battery compartment cover and tighten the screw lightly.
F
F
e
e
d
d
e
e
r
r
a
a
l
l
C
C
o
o
m
m
m
m
u
u
n
n
i
i
c
c
a
a
t
t
i
i
o
o
n
n
C
C
o
o
m
m
m
m
i
i
s
s
s
s
i
i
o
o
n
n
I
I
n
n
t
t
e
e
r
r
f
f
e
e
r
r
e
e
n
n
c
c
e
e
S
S
t
t
a
a
t
t
e
e
m
m
e
e
n
n
t
t
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant
to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful
interference in a residential installation.
This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful interference to radio communications. However,
there is no guarantee that interference will not occur in a particular installation. If this equipment does
cause harmful interference to radio or television reception, which can be determined by turning the
equipment off and on, the user is encouraged to try to correct the interference by one of the following
measures:
. Reorient or relocate the receiving antenna.
. Increase the separation between the equipment and receiver.
. Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
. Consult the dealer or an experienced radio/TV technician for help.
FCC Caution: To assure continued compliance, any changes or modifications not expressly approved by
the party responsible for compliance could void the user's authority to operate this equipment. (Example
- use only shielded interface cables when connecting to computer or peripheral devices).
F
F
C
C
C
C
S
S
t
t
a
a
t
t
e
e
m
m
e
e
n
n
t
t
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:
(1) This device may not cause harmful interference, and
(2) This device must accept any interference received, including interference that may cause undesired
operation.