Specifications

FCC ID: XO8-SLIM418TX rev. A01
Slim 418MHz Transmitter
Model #: SLIM418TX
• Learning-in the Slim Transmitter
Press the Emergency button, a radio signal will be transmitted to the Control
Panel. Please refer to the learn-in procedure of your Control Panel for further instruction.
• Operation
o
To dial Emergency Line:
Press and release the Transmitter button, the GREEN LED will illuminate for .5 seconds and
transmit the message to the Control Panel.
o
Sleep Mode:
-The Transmitter ships in “Sleep Mode” to conserve battery life
-Pressing the Emergency Button once will cause the Transmitter to exit Sleep Mode
• Battery & Electrical Specifications
o
Frequency: 418 MHz
o
Battery: CR1632, 3V 130mAh
o
Battery life: Typical life expectancy of 3 yrs at an average use rate of one activation per day.
o
Open Field Range: 350 ft
o
Low battery status: when the battery voltage is below the threshold, the Transmitter will
indicate a low battery by illuminating the RED LED for .5 seconds when the Emergency button is
pressed. The low battery signal will be transmitted to the Control Panel. A supervisory message
will be sent during a low battery state once every 6 hours.
FCC Statement
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not
cause harmful interference, and (2) This device must accept any interference received, including interference that may cause
undesired operation.
FCC Caution
To assure continued compliance, any changes or modifications not expressly approved by the party responsible for compliance may
void the user’s authority to operate his equipment. (Example – use only shielded interface cables when connecting to computer or
peripheral devices)
FCC Section 15.105 Information to the user.
NOTE:
This equipment has been tested and found to comply with the limits for a class B digital device, pursuant to Part 15 of the FCC
Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This
equipment generates uses and can radiate radio frequency energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not
occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be
determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the
following measures:
-- Reorient or relocate the receiving antenna.
-- Increase the separation between the equipment and receiver.
-- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
-- Consult the dealer or an experienced radio/TV technician for help.