MSDS

ManualsBrandsInstantbond ManualsPaintWorld's Fastest Instant Adhesive Glue - Clear - Cyanoacrylate Glue and Activator Spray - 100/400 ml

MATERIAL SAFETY DATA SHEET (MSDS)

NAME OF PRODUCT: INSTANTBOND

DATE OF ISSUE: Aug 07 2009

1 – Substance Identification

Material/Trade Name: Instantbond

Material Type Cyanoacrylate adhesive

Company Granitec Inc.

Address 535 Millway Avenue

Telephone 905-738-8002

Fax 905-738-8532

2 – Composition

Substance

% Weight

CAS No

EC No

Ethyl-2-cyanoacrylate

Xi: R36/37/38 86-99

7085-85-0

230-391-5

Polymethyl

methacrylate

Xi: R36/37/38 1-14

901-12-7

n/e (polymer)

3 – Hazard Identification

Danger Cyanoacrylate Bonds skin and eyes in seconds. Keep out of the reach of children.

IRRITATING TO EYES, RESPIRATORY SYSTEM AND SKIN.

Avoid contact with sink and eyes.

In case of contact with eyes, rinse immediately with plenty of water and seek medical advice.

Wear suitable gloves.

4 – First Aid Measures

Inhalation: remove to fresh air and rest. If recovery is not rapid call for prompt medical attention

Eyes: Cyanoacrylates bond eyelids in seconds. Irrigate thoroughly with water for at least 15

minutes. Take care not to wash chemical from one eye to another. If the eyelid is bonded

Closed, do not force open. Cover with wet pad soaked in warm water. Get prompt medical

attention, incase solid particles of cured cyanoPacrylate trapped behind the eye causes any

abrasive damage. Keep eye covered with wet pad until debonding is complete, usually 1-3

days. (Cyano-acrylate will bond to eye protein, causing a lachrymatory effect that aids

debonding).

Skin: Do not pull bonded skin apart. Remove contaminated clothing. Wash with soap/cleanser

and rinse with plenty of water. Any bonded skin should be gently peeled apart with the aid

of a blunt object, preferably after soaking in warm, soapy water. If irritation persists, obtain

medical attention. In the case of large spills on skin, superficial burns may occur –treat

accordingly.

Ingestion: Ensure that breathing passages are not obstructed. Give plenty of water to drink. Do

not induce vomiting. The product will polymerize immediately in the mouth, making it

almost impossible to swallow. Saliva will separate the solidified product from the mouth

over a period of hours. Seek medical attention.

5 – Fire-fighting Measures

Suitable Extinguishers: Alcohol resistant foam. Dry powder. Carbon dioxide. Water spray/fog.

Unsuitable Extinguishers: Direct water jets

Summary of content (8 pages)

PAGE 1
MATERIAL SAFETY DATA SHEET (MSDS) NAME OF PRODUCT: INSTANTBOND DATE OF ISSUE: Aug 07 2009 1 – Substance Identification Material/Trade Name: Instantbond Material Type Cyanoacrylate adhesive Company Granitec Inc.
PAGE 2
Hazardous Decomposition: Toxic fumes are produced in fire (CO, CO2, nitrogen oxides). Special Procedures: Do not breathe decomposition products and fumes. Use approved selfcontained breathing apparatus. Wear fire retardant clothing. Wear eye protection. Use water spray to cool containers. Prevent run off from fire control from entering waterways. Large fires should only be dealt with by trained personnel. 6- Accidental Release Measures Exposure Controls: Refer to Section 8- Personal Protection.
PAGE 3
10 – Stability and Reactivity Stable at normal temperatures. Will polymerize rapidly on contact with water. Materials to avoid:s strong oxidizing agents, water, alkalis, amines, alcohols. Conditions to avoid: high temperature, moisture & direct sunlight. No hazardous decomposition products when stored and handled correctly. 11- Toxicological Information Oral: LD50 oral-rat<5000 mg/kg. Considered to have relatively low toxicity. Product is almost impossible to swallow, due to polymerization in mouth.
PAGE 4
b) Other Regulations Health & Safety at work etc.
PAGE 5
SAFETY DATA SHEET ACTIVATOR DATE PREPARED 01.01.2009 1. IDENTIFICATION OF THE PREPARATION AND THE COMPANY: NAME OF COMPANY: GRANITEC INC. NAME OF PRODUCT: INSTANTBOND DATE OF ISSUE: Aug 07 2009 1 – Substance Identification Material/Trade Name: Instantbond Aerosol Activator 2.
PAGE 6
5. FIRE FIGHTING MEASURES: EXTINGUISHING MEDIA Fine water spray, carbon dioxide (C02), foam SPECIAL FIRE FIGHTING PROCEDURES Water may be ineffective but use to keep fire-exposed containers cool. If a leak or spill has not ignited, use water spray to disperse vapors and protect men stopping the leak. Water spray may be used to flush spills away and dilute spills to non-flammable mixtures. Use water spray to reduce vapors. Warn fire fighters that aerosols are involved.
PAGE 7
9. PHYSICAL AND CHEMICAL PROPERTIES: Appearance Aerosol container containing a mixture of active ingredients, solvents and propellants Odour Solvent 10. STABILITY AND REACTIVITY: CONDITlONS TO AVOID Heat flames and other sources of ignition MATERIALS TO AVOID HAZARDOUS DECOMPOSITION PRODUCTS 11. TOXICOLOGICAL INFORMATION: HEALTH WARNINGS Narcotic effect. Drowsiness. Concentrating and inhaling the gas can lead to abnormal heart rhythms and possibly death.
PAGE 8
3. RID (Transport by Rail) CLASS PACKING DANGER LABEL PACKAGES 4. ADNR (Transport by Inland Waterways) CLASS PACKING DANGER LABEL PACKAGES 5. IMDG (Maritime Transport) CLASS 2 PACKING MFAG EMS MARINE POLLUTANT 6. ICAO (Air Transport) CLASS ACKING 15. REGULATORY INFORMATION: LABEL FOR SUPPLY According to EC-Directives 67/548/EEC on 1999/45/EC Extremely Flammable Harmful RISK PHRASES R10 R20 R36/37/38 R42/43 Flammable Harmful by inhalation Irritating to the eyes, respiratory system and skin.