User's Manual

IPCAM User manual

 Alarm Service Settings

Enter Alarm Service Settings page to configure Motion Detection function.

Motion Detect Armed

When you enable motion detect armed, the camera can be triggered to send email alerts

sound you will hear.

Motion Detect Sensibility

You can choose level 1-10, level 1 means the most sensitive, 10 means the least of all

I/O PINS: 1 Output (+5V) 2 Output 3 Alarm input 4 Input (GND)

Alarm Input Armed

Input pins: The input pins can be used for 1-way external sensor input For example; you

may connect a person Infrared Sensor (PIP) to it for motion detection. When external

sensor triggered,

IP CAMERA can be programmed to send an email with picture or control the internal relay

output.

If you link an external alarm with Pin3 and Pin4, when enable alarm input armed ,external

alarm is enabled

IO Linkage on Alarm

Enable IO linkage on alarm, Pin 1 will output +5V when alarm triggered, and output LOW

when alarm release automatically.

Switch on/off buttons control Pin1 output manually.

Send Mail on Alarm

Sent picture and mail inform to customer’s e-mail after alarmed. (Firstly you should finish

the Mail Service Settings.)

Upload Image on Alarm

Enable upload image on alarm and set upload interval (Seconds).

REC automatically and save to PC

When you enable motion detect and open the camera monitoring page on the PC. If there

is an alarm triggered, REC will start automatically for several seconds and save to the PC.