Color Change Kit Instructions

SwitchLinc Paddle

Color Change Kit

2400AL, Almond

Introduction

This kit allows the user to easily change the

SwitchLinc paddle. The front panel and frame on

SwitchLinc can be removed before or after

installation.

During the change-over process, the power and the

load may remain on and operating. There are no

dangerous voltages or unsafe areas under the

paddle.

Kit Contents

• Two assembled paddle and frame assemblies

• Four extra screws

1) If SwitchLinc is already installed in the wall,

remove the wallplate

2) Remove the four Phillips screws that hold the

paddle assembly to the metal frame

3) Pull the entire frame straight away from the

switch. You may have to wiggle the bottom of

the frame to get it free of the Set button.

4) Using a flat blade or needle nose pliers,

remove the large light pipe as shown in Figure

2. The light pipe will snap out of the frame.

Do the same for the small light pipe.

Figure 1: Paddle assembly and

SwitchLinc body separated

Figure 2: Snap out the light

pipes with a flat tool

PAGE 1
SwitchLinc Paddle Color Change Kit 2400AL, Almond Introduction Kit Contents This kit allows the user to easily change the SwitchLinc paddle. The front panel and frame on SwitchLinc can be removed before or after installation. • Two assembled paddle and frame assemblies • Four extra screws During the change-over process, the power and the load may remain on and operating. There are no dangerous voltages or unsafe areas under the paddle.
PAGE 2
5) Orient the small light pipe with its protrusion facing toward the center of the new frame and snap it into place. If placed in backwards or reversed, it will not click into place. Refer to Figure 3. 6) Orient the new light pipe with the side that has the most protrusions facing toward the center of the new frame. Using only finger pressure, snap the light pipe into the frame.