Color Change Kit Instructions

5) Orient the small light pipe with its protrusion

facing toward the center of the new frame

and snap it into place. If placed in

backwards or reversed, it will not click into

place. Refer to Figure 3.

6) Orient the new light pipe with the side that

has the most protrusions facing toward the

center of the new frame. Using only finger

pressure, snap the light pipe into the frame.

7) If both light pipes are installed correctly, they

will stick straight out from the back of the

frame. If installed incorrectly, they will

appear to be tilted (see Figures 4 and 5).

8) Gently place the paddle assembly back onto

the front of SwitchLinc. A little force may be

necessary to snap the assembly over the Set

button. Test by pressing the paddle

top/bottom to properly ensure the paddle is

“seated”, and then adjust/reinstall as

required. Reinstall the four screws you

removed in step 2.

Smarthome Limited Warranty

Smarthome warrants that this product will be free from defects in material

and workmanship, and will perform in substantial conformity to the

description of the product. This warranty shall not apply to defects or

errors caused by misuse or neglect.

If the product is found to be defective in material or workmanship or if the

product does not perform as warranted above during the warranty period,

Smarthome will either repair it, replace it or refund the purchase price, at

its option, upon receipt of the product at the address below, postage

prepaid, with proof of the date of purchase and an explanation of the

defect or error. The repair, replacement, or refund that is provided for

above shall be the full extent of Smarthome’s liability with respect to this

product.

For repair or replacement during the warranty period, call Smarthome

Customer Service to receive an RA# (return authorization number),

properly package the product (with the RA# clearly printed on the outside

of the package) and send the product, along with all other required

materials to:

Smarthome - ATTN: Receiving Dept.

16542 Millikan Ave.

Irvine, CA 92606-5027

Rev 01-26-2011 www.smarthome.com

Figure 3: Insert the light pipes with the

protrusions facing the center into the new frame

ure 4: Installed correctl

Figure 5: Installed incorrectly