User's Manual

2444-222, 2444-422, 2444-522 Rev. 2/24/2014 9:18 AM / See Owner’s Manual for Warranty Information.

Protected under U.S. and foreign patents (see www.insteon.com/patents)

Quick Start Guide

INSTEON

Micro Open/Close (Shutter)

Model: 2444-222/2444-422/2444-522

What’s Needed

• Slotted #1 screwdriver • Voltage meter

• Philips screwdriver • Wire cutter/stripper

Installing Micro Module

Installation should only be performed by a qualified electrician or a homeowner

who is familiar and comfortable with electrical circuitry. If you have questions,

consult an electrician or call the INSTEON Support Line at 866-243-8022

1) Write down the INSTEON ID found on the back of the unit (XX.XX.XX)

2) Turn off breaker/fuse and verify that the power is off

3) Disconnect wires from existing switch, fixture or outlet and prep all wires to

be connected to Micro module, with 3/16” (5mm) of bare wire on the ends

4) Connect wires per diagram which corresponds to your installation

Note: sense lines carry very low current (~0.35mA 240V, ~0.17mA for 120V)

5) After ensuring wires are firmly connected and that there is no exposed wire, turn on breaker/fuse

After a few seconds, Micro module LED will turn green

6) Test by tapping Micro module up/down buttons

Motor will respond accordingly

Micro Module LED will turn green when motor is moving up/open and stay green until the down button is pressed

Micro Module LED will turn red when motor is moving down/closed and stay red until the up button is pressed

7) If installing a single momentary or dual momentary switch

a) Press and hold set button until it beeps

LED will start blinking green

b) Press and hold set button until it beeps a second time

LED will start blinking red

Sense #2

(down - purple)

LED

Sense #1

(up - yellow)

Antenna

EU/AUS/NZ

North America

Down

PAGE 1
LED Quick Start Guide Sense #2 (down - purple) INSTEON® Micro Open/Close (Shutter) Model: 2444-222/2444-422/2444-522 What’s Needed • • Slotted #1 screwdriver Philips screwdriver • • Voltage meter Wire cutter/stripper Sense #1 (up - yellow) Installing Micro Module Installation should only be performed by a qualified electrician or a homeowner who is familiar and comfortable with electrical circuitry.
PAGE 2
c) Press and hold set button until it beeps a third time LED will start blinking green d) Perform the step that applies • For single momentary: slowly tap set button four times LED will continue blinking green • For dual momentary: slowly tap set button five times LED will start double-blinking green • To switch back to latching: slowly tap set button six times LED will start blinking green e) Once the mode is selected, press and hold set button until it double-beeps LED will stop blinking and turn green if
PAGE 3
Make Micro Module a Controller These settings can be configured remotely via software (sold separately). You can also add Micro module to your network manually by following the instructions below. Note: you must perform these steps before reinstalling the wall switch.