INSTEON On/Off Switch 2477S Quick Start Guide
INSTEON On/Off Switch On LED On Status LED Off Set Button For the complete Owner’s Manual and more, visit: insteon.
Tools Needed for Installation Phillips Screwdriver Flathead Screwdriver Voltage Detector Wire Cutter / Stripper Disconnect Power Always disconnect power before installation. Contact INSTEON Support when uncertain about installation.
Basic Installation 1 Turn off power to your switch at the electrical service panel.
2 Remove the old switch and disconnect the wires. If your box lacks neutral wires, stop and contact support.
3 Turn on power at the circuit breaker and use a voltage detector or multi-meter to identify line and load. Line will be energized.
4 Turn off power at the circuit breaker. Connect the junction box. Verify that the wire nuts are s except for the bare ground wire.
the On/Off Switch wires to the identified wires in secure and that no exposed copper wire is visible Neutral Ground
5 Mount the On/Off Switch into the junction box with the LED bar on the left and turn power on to the switch at the circuit breaker panel.
6 Test your On/Off Switch by tapping the paddle to turn On and Off. Installation complete. You can now link your On/off Switch to the Hub.
Linking to the Hub Follow the on-screen instructions to add your On/Off Switch to the INSTEON Hub. + When prompted, press and hold the On/Off Switch’s set button. ! If not using the Hub, refer to the instructions that came with your product.
Device Control Turn on, turn off, set schedules and create scenes for your On/Off Switch using the INSTEON Hub and App. On/Off Switch Protected under U.S. and foreign patents (see www.insteon.com/patents) ©2014 INSTEON RAW-1292 Rev 03.13.
