INSTEON On/Off Switch 2477S Quick Start Guide Guide de départ rapide
INSTEON On/Off Switch On LED Voyant à DEL de mise en fonction NEW On En fonction Status LED Voyant à DEL d’état Off Hors fonction Set Button Bouton de réglage MANUAL For the complete Owner’s Manual and more, visit: insteon.com/support X Afin de consulter le guide d’utilisation complet et plus, visitez : insteon.
Tools Needed for Installation Outils requis pour l’installation Phillips Screwdriver NEW Tournevis Phillips Flathead Screwdriver Tournevis à tête plate Voltage Detector Détecteur de tension Wire Cutter / Stripper Pince coupe-fil/à dénuder Disconnect Power Coupez l’alimentation X Always disconnect power before installation. Contact INSTEON Support when uncertain about installation. Coupez toujours l’alimentation avant de procéder à l’installation.
Installation Installation 1 Turn off power to your switch at the electrical service panel. Coupez l’alimentation de l’interrupteur à partir du panneau électrique.
2 Remove the old switch and disconnect the wires. If your box lacks neutral wires, stop and contact support. Débranchez les câbles de l’interrupteur actuel. Assurez-vous de laisser environ ½ po de câble dénudé à l’extrémité.
3 Turn on power at the circuit breaker and use a voltage detector or multi-meter to identify line and load. Line will be energized. Mettez l’alimentation sous tension à partir du disjoncteur et utilisez un détecteur de tension ou un multimètre pour distinguer la tension secteur de la charge. La tension du secteur sera active (sous tension).
4 Turn off power at the circuit breaker. Connect the On/Off Sw the wire nuts are secure and that no exposed copper wire i Coupez l’alimentation du disjoncteur.
witch wires to the identified wires in the junction box. Verify that is visible except for the bare ground wire. ur aux fils correspondants dans la boîte de connexion. Assurez-vous que les osé ne soit visible, à l’exception du fil de mise à la terre.
5 Mount the On/Off Switch into the junction box with the LED bar on the left and turn power on to the switch at the circuit breaker panel. Installez l’interrupteur de mise en/hors fonction dans la boîte de connexion en positionnant la barre à DEL à gauche et mettez l’interrupteur sous tension, sur le panneau des disjoncteurs.
6 Test your On/Off Switch by tapping the paddle to turn On and Off. Testez votre interrupteur de mise en/hors fonction en tapant sur la plaquette pour mettre en/hors fonction. NEW Installation Complete. You can now link your On/Off Switch to the Hub. X L’installation est terminée. Vous pouvez maintenant effectuer la liaison de votre interrupteur de mise en/hors fonction au Hub.
Linking to the Hub Liaison avec le Hub Follow the on-screen instructions to add your On/Off Switch to the INSTEON Hub. Suivez les instructions à l’écran pour ajouter votre interrupteur de mise en/hors fonction au Hub d’INSTEON. + NEW When prompted, press and hold the On/Off Switch’s set button. Lorsqu’on vous y invite, maintenez enfoncé le bouton de réglage de la prise murale de mise en/hors fonction. If not using the Hub, refer to the instructions that came with your product.
Device Control Contrôle du dispositif Turn on, off, set schedules and create scenes for your On/Off Switch using the INSTEON Hub and App. Mettez le dispositif en fonction, puis mettez-le hors fonction, entrez des programmations et créez des scènes pour votre interrupteur de mise en/hors fonction* à l’aide du Hub et de l’application d’INSTEON. On/Off Module On/Off Switch ON Protected under U.S. and foreign patents (see www.insteon.