User Guide

Rev. 7/16/2012 12:38 PM / See Owner’s Manual for Warranty Information, Patented
© Copyright 2012, INSTEON, 16542 Millikan Ave., Irvine, CA 92606, 800-762-7845
Using KeypadLinc
The ON/OFF buttons control the load (the device wired directly to KeypadLinc) as well as any linked responders
• Tap ON button to turn on the load
• Tap OFF button to turn off the load
The scene buttons control any responders linked to that particular scene/button. When the LED of a button is lit, its
scene has been activated. Tap the buttons to toggle the scenes on and off.
Quick Start Guide
KeypadLinc
™
On/Off Switch (Dual-Band)
Model: 2487S
Installation
Note: Installation should be performed only by a qualified electrician or
a homeowner who is familiar and comfortable with electrical circuitry. If
you have any questions regarding installation, consult an electrician or
call the INSTEON Support Line at 800-762-7845.
1) At the circuit breaker or fuse panel, disconnect the power for all of
the circuits in the switch junction box. Verify that the power is off by
trying to turn on the lights controlled by the switches.
2) Remove the wallplate from the switch junction box, and then
unscrew the switch you are replacing and pull it out from the
junction box
3) Disconnect the wires from the switch you are replacing. If the wires
cannot be detached by unscrewing them, cut the wires where they
enter the switch, then strip ½” of insulation off the ends.
4) If you are installing KeypadLinc into a standard 2-way circuit
(where only one switch controls the load), follow the diagram below
to identify and connect the line, load, neutral and ground wires.
If the colors of the wires do not match the diagram, be sure you
have identified the wires correctly before connecting them.
5) If you are installing KeypadLinc into a multi-way circuit (where
more than one switch controls the load), please refer to the manual
6) After you have connected all of the wires, ensure that all of the
wire connectors are firmly attached and that there is no exposed
copper except for the ground wire
7) Orienting KeypadLinc with the Set button on the bottom, gently
place it into the junction box, and then screw it into place.
8) Enable power to the KeypadLinc from the circuit breaker or fuse
panel
KeypadLinc’s ON button will turn on
9) Test that KeypadLinc is working properly by tapping the ON and
OFF buttons
10) Reinstall the wallplate
Set button (push)
Air gap (pull)
Wallplate
(sold separately)
On/Off buttons
(load-controlling)
Scene
button