Owner's Manual

Page 4 of 7 Rev: 10/28/2013 8:11 AM
5) Test by tapping Leak Sensor Set button. Responder will turn on.
6) To add multiple responders, repeat steps 1-5 for each additional responder
Remove Leak Sensor as a Controller (Unlink)
1) Press and hold Leak Sensor Set button until the status LED begins blinking
LED will start blinking green
2) Press and hold Leak Sensor Set button again until the status LED blink cadence changes
LED will continue blinking
3) Press and hold responder Set button until it double-beeps
Leak Sensor’s LED will stop blinking
4) Test by tapping Leak Sensor Set Button with Responder in the Off state
Former responder will not respond
Factory Reset
All settings and scenes will be erased.
1) Using a small flat blade screwdriver, carefully open the bottom case of Leak Sensor
2) Pull out the battery
3) Wait 5 seconds
4) Push in Set button and hold it. Do not let go.
5) Reinstall the battery while holding down the Set button
LED will turn on solid Green for a few seconds
LED will then turn off
6) Release Set button