INSTEON Dimmer Switch Quick Start Guide
INSTEON Dimmer Switch Brightness LEDs On Hold to Brighten Status LED Off Hold to Dim Heat Sink Tab (1000W Only) Set Button For the complete Owner’s Manual and more, visit: insteon.
Tools Needed for Installation Phillips Screwdriver Flathead Screwdriver Voltage Detector Wire Cutter / Stripper Disconnect Power Always disconnect power before installation. Contact INSTEON Support when uncertain about installation.
1 Installation Turn off power to your switch at the electrical service panel.
2 Remove the old switch and disconnect the wires. If your box lacks neutral wires, stop and contact support.
3 Turn on power at the circuit breaker and use a voltage detector or multi-meter to identify line and load. Line will be energized.
4 Turn off power at the circuit breaker. Connect the junction box. Verify that the wire nuts are s except for the bare ground wire.
the Dimmer Switch wires to the identified wires in secure and that no exposed copper wire is visible Neutral Ground
5 Mount the Dimmer Switch into the junction box with the LED bar on the left and turn power on to the switch at the circuit breaker panel.
6 Test your Dimmer Switch by tapping the paddle to turn On and Off. Press and hold to dim or brighten. Installation complete. You can now link your Dimmer Switch to the Hub.
Linking to the Hub Follow the on-screen instructions to add your Dimmer Switch to the INSTEON Hub. + When prompted, press and hold the Dimmer Switch’s set button. ! If not using the Hub, refer to the instructions that came with your product.
Device Control Dim, brighten, set schedules and create scenes for your Dimmer Switch using the INSTEON Hub and App. Dimmer Switch Protected under U.S. and foreign patents (see www.insteon.com/patents) ©2014 INSTEON RAW-1290 Rev 03.26.
