user manual

Page 9 of 15 Rev: 1/21/2014 7:29 AM
7) Test by tapping controller button on and off
SwitchLinc and all scene responders will turn on (to desired brightness/states) and off
Remove SwitchLinc as a Controller (Unlink)
1) Press and hold SwitchLinc Set button until it beeps
LED will start blinking green
2) Press and hold SwitchLinc Set button until it beeps
LED will start blinking red
3) Press and hold responder Set button until it double-beeps
SwitchLinc will double-beep and its LED will stop blinking
4) Test by tapping SwitchLinc on and off
Former responder will not respond
Remove SwitchLinc as a Responder (Unlink)
If you no longer want a controller button to control SwitchLinc follow these directions. Important: perform
these steps for all controllers of SwitchLinc before removing SwitchLinc from use. Otherwise, controllers
will retry commands repetitively, creating network delays.
1) Press and hold controller button until it beeps
Controller LED will start blinking
2) Press and hold controller button until it beeps
Controller LED will continue blinking
3) Press and hold SwitchLinc Set button until it double-beeps
Controller LED will stop blinking
4) Test by tapping controller button on and off
SwitchLinc will no longer respond
Change Paddle or LED Colors
You can swap out the included white LEDs and/or front paddle and trim frame assembly with a color-
change kit before or after SwitchLinc is installed. For more information, see the
Accessories page on
INSTEON.com.
Using Air Gap
Anytime you want SwitchLinc’s controlled load to be unpowered but don’t want to turn off the circuit
breaker—such as when replacing light bulbs—use the air gap to quickly and conveniently disable power
to the connected load.
Using your fingernail or a small flathead screwdriver, pull out SwitchLinc Set button as far as it will go
(about 1/8”). This opens the mechanical contacts and removes all power from the SwitchLinc and its load.
(Because SwitchLinc’s settings are stored in its non-volatile memory, your setup information will not be
lost.) To re-enable power to SwitchLinc, simply push in the Set button until it is flush with the trim frame.
Factory Reset
All settings and scenes will be erased.
1) Pull out SwitchLinc Set button to remove power
2) Wait 5 seconds
3) Push in Set button and hold it. Do not let go
SwitchLinc will emit a long beep