INSTEON Motion Sensor 2842-222 Quick Start Guide
INSTEON Motion Sensor Status LED ® Wall Mount Retention Slot Settings Jumpers Set Button 9V Battery (Included) (Cover Removed)
Jumper Settings To configure settings like Night-Only mode and Light Sensitivity via the INSTEON Hub, ensure jumper five is installed over both pins.
Sensor PlacementNEW Affix the mount to a surface and slide the mount into the retention slot on the rear of the sensor. Avoid areas of rapid heat change.
Linking to the Hub 1 Follow the on-screen instructions to add your Motion Sensor to the INSTEON Hub. + ! If not using the Hub, refer to the instructions that came with your product.
NEW 2 Remove the back cover and when prompted, press and hold the set button until the status LED begins blinking. Tap the set button. The status LED will double-blink.
Configure Alerts To receive email and text message alerts when motion is detected, switch on alerts from device settings within the INSTEON app. ! ! Trigger a Scene Add your Motion Sensor to a scene using the INSTEON Hub and it will control the scene.
Learn More For the complete Owner’s Manual, video tutorials, product support and more, visit: insteon.com/support MANUAL Protected under U.S. and foreign patents (see www.insteon.com/patents) ©2014 INSTEON RAW-1297 Rev 03.13.