user manual

ManualsBrandsINSTEON ManualsSurge ProtectorSurge Protector 2473S

2473S Rev. 11/8/2012 6:54 PM / See Owner’s Manual for Warranty Information.

Protected under U.S. and foreign patents (see www.insteon.com)

Quick Start Guide

INSTEON

OutletLinc™ On/Off Outlet

Model: 2473S

Tools Needed

• Flathead screwdriver • Phillips screwdriver

• Wire cutter/stripper • Voltage tester

Installing OutletLinc

Installation should only be performed by a qualified electrician or a homeowner who is

familiar and comfortable with electrical circuitry. If you have questions, consult an electrician

or call the INSTEON Support Line at 866-243-8022

1) At the circuit breaker or fuse panel, disable circuit supplying power to outlet

2) Remove existing outlet and wallplate

3) Disconnect wires from existing outlet and ensure you have ½” of bare wire on the ends

4) Enable power to the outlet, then use voltage meter to identify line, neutral and ground

wires. Once wires are identified, turn off circuit breaker.

5) Twist OutletLinc ground wire (bare copper) to outlet ground wire with included wire nut

6) Twist OutletLinc neutral wire (white) to outlet neutral wire with included wire nut

7) Twist OutletLinc line wire (black) to outlet line wire with included wire nut

8) After ensuring all wire connectors are firmly attached and that there is no exposed copper (except for ground wire), carefully

place OutletLinc into wall box and replace wallplate

9) Turn on circuit breaker

10) Plug lamp, appliance or other device you want to control (load) into OutletLinc top outlet

11) Test by tapping OutletLinc Set button a few times

Connected light/load will turn on and off

Make OutletLinc a Responder

Control OutletLinc from another INSTEON device:

1) Put controller into linking mode.* (For most controllers press and hold Set button for 3 seconds or an on/scene button for 10

seconds.)

2) Turn on load plugged into OutletLinc

3) Press and hold OutletLinc Set button for 3 seconds

Status LED will flash, then turn on solid

4) Confirm link by tapping controller’s button on and off

Connected light/load will turn on and off

Owner’s Manual and Tech Support

For the complete Owner’s Manual and the most up-to-date Quick Start Guide visit: http://www.insteon.com/support

Call: INSTEON Support Line at 866-243-8022

*Linking mode will time out after 30 seconds

Set

button

INSTEON controlled

on/off receptacle

Status

LED

Always-on uncontrolled

receptacle