Owner manual

Page 13 of 16 Rev: 1/21/2014 7:12 AM
X10
X10 address
1 optional (comes unassigned)
X10 transmitter
Yes
X10 receiver
Yes
X10 status response
Supported
X10 resume dim
Supported (by setting local on-level to zero)
X10 minimum transmit level
3.2 Vpp into 5 Ohms
X10 minimum receive level
20mV into 5 Ohms
Mechanical
Mounting
Standard North American single or multi-gang electrical boxes
Wires
Line (black) – 16 gauge
Load (red) – 16 gauge
Neutral (white) – 16 gauge
Ground (bare copper) – 16 gauge
Back case color
Clear
Switch paddle and frame color
White, almond, light almond, ivory, gray, black or brown
Set button
1
Plastic
UV stabilized polycarbonate
Beeper
Yes
Beep on button press
Optional (off by default)
Status LEDs
1 dual-color red/green and 9 white
Dimensions
4.1” x 1.8” x 1.2” (104.1mm x 45.7mm x 30.5mm)
Depth into electrical box
0.99” (25mm)
Weight
3.6 oz. (102 grams)
Operating environment
Indoors
Operating temperature range
32
°
to 104
°
F (0
°
to 40
°
C)
Operating humidity range
0-90% relative humidity, non-condensing
Storage temperature range
-4
°
to 158
°
F (-20
°
to 70
°
C)
Electrical
Voltage
100-277VAC (+/- 10%) (Rev. 7.0 models and later, earlier models are 120v
Neutral connection required
Yes
Frequency
50/60Hz, auto detected at power-up
Load type(s)
Incandescent
Maximum dimmer load 600 watts
Surge resistance
Up to 500VAC
User replaceable fuse
No
Hardwired remote control
No
Retains all settings without power
Yes, saved in non-volatile EEPROM
Standby power consumption
<1 watts
Certifications
FCC, IC Canada
FCC ID
SBP2477D and 5202A-2477D
Safety approval(s)
ETL (Intertek Testing Services) to UL/ANSI standard 1472