User Manual

SynchroLinc Owner’s Manual
Page 5 of 12
Product Use Restrictions
Use onl y as directed in the ins tructions and withi n the spec ificatio ns and en vironm ental conditi ons below .
Using SynchroLinc in a different manner or outside the conditions below may defeat the safety features
and protection against electrical shock and fire.
• 120 Volts AC +/- 10% , 60 Her t z, 15 Am ps maxi mum continuous
• Indoor use only
• Temperature 41° to 104° F (5° to 40° C)
• Maximum relative humidity 80% for temperatures up to 87° F (31° C) decreasing linearly to 50%
relative humidity at 104° F (40° C)
• Altitude up to 6,500 feet (2,000 meters)
• Installation Category II
• Pollution Degree 2
Installing SynchroLinc
1) Plug the desired device (also called the load) into the outlet on SynchroLinc
2) Plug SynchroLinc into an unswitched outlet
SynchroLinc will beep
The SynchroLinc Status LED will turn on solid green or solid red
After 20 seconds, SynchroLinc will double-beep and enter Calibration Mode
You will have 4 minutes to calibrate SynchroLinc before Calibration Mode automatically times out.
Once Calibration Mode times out, SynchroLinc will ignore all button taps.
NOTE: If you plan to us e Synchr oLinc w ith INSTEO N hom e automation sof tware (e.g., H ouseLinc 2), wait
until SynchroLinc enters Calibration Mode (after the double-beep) to add it to the software.
Calibrating S ynchroLinc
1) Make sure the load is off or in its standby state
2) Wait at least 10 seconds and then tap the Set button on SynchroLinc to record the off/low energy
state
SynchroLinc will beep
3) Turn the load on or set it to its high energy state
4) Wait at least 10 seconds and then tap the Set button to record the on/high energy state
SynchroLinc will double-beep and its Status LED will turn on solid green when the load is in its
high energy state and red when it is in its low energy s tate
If you would like to reset the energy states or if SynchroLinc times out of Calibration Mode, unplug the
SynchroLinc and reinstall. See Installing SynchroLinc.