User's Manual

Communication Failures
134
11
3. If at any point in this process the PDM can communicate
again with the Pod, you will see either:
a. Figure 11-5, indicating that your original instruction or
command was successfully sent to the Pod. When you
press OK, or within 5 seconds, the System displays the next
screen in the command sequence you were entering.
b. Figure 11-6, indicating that your last command was not
sent to the Pod. Press OK.
If you were activating a Pod, the System returns to the pre-
vious screen, where you can continue activation. If you
were issuing any other command, the System returns to
the Status screen, where you can reissue the command.
■ Failure During Pod Deactivation
To review the deactivation process, see “Deactivate the current
OmniPod” in Chapter 5, Using the OmniPod.
If you press Confirm to deactivate the active Pod and the PDM
cannot send your instruction to the Pod, you will see the screen
in Figure 11-7.
Either:
1. Press Retry to try deactivating the Pod again. If the PDM still
cannot send the instruction, you will see Figure 11-7 again.
Follow step 2.
Figure 11-5 Figure 11-6
Figure 11-7