Users Manual
51
Setting Up Your Omnipod5 Application 4
Dene the segments
You can create up to 24 segments within
your midnight to midnight Basal Program.
e Start Time for the rst segment is
always 12:00AM.
1. Tap the End Time eld and scroll to
select the desired end time.
2. Tap the Basal Rate eld and scroll to
select the basal rate for the segment.
Note: e Maximum Basal Rate that
you entered earlier is displayed under
the Basal Rate text. You cannot enter a
basal rate greater than this number.
Note: e two vertical blue lines on the
graph near the top of the screen show
the start and end time for the basal
segment. e selected basal rate for
the segment is shown between the two
vertical lines.
3. Check the values of your start and end
times and the basal rate. en tap NEXT.
4. If the Basal Program does not cover 12:00AM-12:00AM you must add
additional segments. Repeat steps 1-3 as needed until your nal segment ends
at midnight.
Review the Basal Program
e next screen summarizes the start and
end times, and basal rate for each segment
of the Basal Program.
1. Tap CONTINUE to review your Basal
Program.
2. Check that the graph and the individual
segment values are correct.
e total daily amount of basal insulin
to be delivered by this Basal Program is
listed below the graph.
3. To change an end time or basal rate for
a segment:
a. Tap the row containing the segment
you would like to change.
Starting
Your
OmniPod 5
Effective Date: 22DEC2020, PCO-000267