User's Guide

Initial PDM Setup 2
28
2 Initial PDM Setup
Note: e two vertical blue lines on the graph near the top of the screen show
the start and end time for the basal segment. e selected basal rate for the
segment is shown between the two vertical lines.
3. Check the values of your start and end times and the basal rate. en tap
NEXT.
Dene additional segments
If the Basal Program does not cover 24-hours, you must add additional segments:
1. Tap the End Time eld and select the duration of the next segment.
2. Tap the Basal Rate eld and select the basal rate for the segment.
3. Review the segment details and the graph.
4. Tap NEXT to move to the next segment.
5. Repeat the preceding steps as needed until your nal segment ends at
midnight.
Aer specifying a basal rate for the nal segment, your Basal Program is complete.
Review the Basal Program
e next screen summarizes the start and end times, duration, and basal rate for
each segment of the Basal Program.
1. Tap CONTINUE to review your Basal
Program.
2. Check that the graph and the
individual segment values are correct.
e total daily amount of basal insulin
to be delivered by this Basal Program
is listed below the graph.
3. To change an end time or basal rate for
a segment:
a. Tap the row containing the
segment you would like to change.
b. Tap the End Time eld, and enter
the new end time for the segment.
c. Tap the Basal Rate eld, and enter
the desired basal rate.
d. Tap NEXT.
e. en dene the end time and basal
rate for any following segments, as needed.