Datasheet

INSYS GSM 4.2 easy Configuration with the Software HSComm easy
January 07 29
5.4 Status Bar
The status bar at the lower window border of the HSComm displays the setting
and activities of the serial interface. RX, TX light up synchronously when receiving,
and sending data.
5.5 Buttons
5.5.1 Send settings
The current settings in the HSComm are
transferred to the INSYS GSM 4.2 easy.
The settings in the PLC window are only
transferred by clicking the button Send SPS
configuration.
5.5.2 Read settings
The current settings of the INSYS GSM 4.2 easy are
read out and displayed in the HSComm.
5.5.3 Send default settings
The default factory settings are loaded and a reset is executed. Afterwards, the
device re-registers at the GSM network if the PIN is stored.
5.5.4 Reset
Software reset of the INSYS GSM 4.2 easy. Afterwards, the device re-registers at
the GSM network if the PIN is stored.
5.5.5 Synchronize
The serial interfaces of the INSYS GSM 4.2 easy and the connected device have to
be configured equally. With "Synchronize", all possible baud rates and data format
settings at the PC side are tested until both sides match.
5.5.6 Abort
Terminates an ongoing configuration process (Send values, read settings, send
default settings – indicated by the progress bar above the buttons).