User's Manual

5 PRINTER OPERATION

5.3.3 Pause to change material

If the printer is printing but the user needs to change the material, the operations are as below:

1. Click the “Pause” button in "Print" interface on the screen, and wait until the movement of the

printer's nozzle stops completely;

2. Unload the old material.

3. Load the new material.

4. After the completion of loading, click the “Start” button in "Print" interface on the screen to

continue the printing.

5.3.4 Replenish material after starved feeding alarm

The printer is equipped with the function of starved feeding alarm. When the materials is used out, the

printer stops working, and meanwhile an alarm code will be popped up on the screen to reminder user to

change material. Click "Supply filament" button on the screen and then change material according to the

instructions on screen. The operations to replenish material are as below:

1. Unload the old material.

2. Load the new material.

3. After the completion of loading, click the “Start” button in "Print" interface on the screen to

continue the printing.

Figure 5. 10 Starved feeding alarm interface

5.4 Basic Printing Operations

5.4.1 Prepare the printer

To prepare the printer to be used for printing:

1. Power on the printer (refer to 5.1.1 for details);

2. Clear the material residues on the nozzle brush the inside the chamber;

3. Clean the printing buildplate, and apply printing glue. Before the installation, clean the printing

buildplate with water and wipe dry it, and then evenly apply glue for printing base plate on the